Array Shape Observability From Time Differences of Arrival
- 15 April 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 47 (2) , 1515-1520
Abstract
In this paper, we study the observability conditions for the relative position of a set of passive sensors from the measured time differences of arrival (TDOA) of signals from a set of noncooperative sources lying in the same plane. The sources are broadband to measure the TDOA and far enough to consider each source is detected in the same line of sight by each sensor. We show that a necessary observability condition is to have at least three sensors and three sources. Then, the sufficient observability conditions are established in this minimal configuration. Finally, we propose an algorithm to compute both sensors' location and the direction of arrival (DOA) of the sources, from the noise-free TDOA.Keywords
This publication has 7 references indexed in Scilit:
- Sensor Self-Localization for Antenna Arrays Subject to Bending and VibrationsIEEE Transactions on Aerospace and Electronic Systems, 2010
- Observability and fisher information matrix in nonlinear regressionIEEE Transactions on Aerospace and Electronic Systems, 2007
- Array Shape Self-Calibration for Large Flexible Antenna2007
- Observability conditions for multiple signal direction finding and array sensor localizationIEEE Transactions on Signal Processing, 1992
- Array shape calibration using sources in unknown locations--Part II: Near-field sources and estimator implementationIEEE Transactions on Acoustics, Speech, and Signal Processing, 1987
- Array shape calibration using sources in unknown locations--Part I: Far-field sourcesIEEE Transactions on Acoustics, Speech, and Signal Processing, 1987
- A self-survey technique for self-cohering of antenna systemsIEEE Transactions on Antennas and Propagation, 1978