Formation of strength platform in cast Al–Si–Mg–Cu alloys
Open Access
- 3 July 2019
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 9 (1) , 1-11
Abstract
Over the past several decades, it was generally believed that the strength of the industrially widely used cast Al–Si–Mg–Cu alloys enhanced monotonously with increasing Cu content. However, in this study using cast Al9Si0.5MgxCu (x = 0,0.2,0.4,0.6,0.85,1.0,1.25, in wt.%) alloys under T6 heat-treated condition, it was found that the hardness and yield strength of the heat-treated alloys showed a platform in the composition range from 0.4 wt.% to 0.85 wt.% Cu, while still increased with increasing Cu content before and after the platform. With increasing Cu content, the β-Mg2Si intermetallic phase decreased and disappeared at 0.85 wt.% Cu, while the Q–Al5Cu2Mg8Si6 and θ–Al2Cu intermetallic phases increased in the as-cast alloys. After heat treatment, the micron-scale intermetallic phases were dissolved into the Al matrix and precipitated as the nanoscale β″, Q′ and θ′ strengthening phases. With increasing Cu content, the β″ precipitate decreased and vanished at 0.85 wt.% Cu, while the Q′ and θ′ precipitates increased in the heat-treated alloys. The trade-off of the phases induces the platform in the strength of the heat-treated alloys, and further increase of the Cu content in this undetected trapped platform range is not favorited industrially as it only decreases ductility.Keywords
This publication has 30 references indexed in Scilit:
- Si poisoning and promotion on the microstructure and mechanical properties of Al–Si–Mg cast alloysJournal of Materials Science, 2018
- High performance gravity cast Al9Si0.45Mg0.4Cu alloy inoculated with AlB 2 and TiB 2Journal of Materials Processing Technology, 2018
- Breaking through the strength-ductility trade-off dilemma in an Al-Si-based casting alloyScientific Reports, 2016
- Effects of Cu content and Cu/Mg ratio on the microstructure and mechanical properties of Al–Si–Cu–Mg alloysJournal of Alloys and Compounds, 2015
- Influence of Aging Parameters on the Tensile Properties and Quality Index of Al-9 Pct Si-1.8 Pct Cu-0.5 Pct Mg 354-Type Casting AlloysMetallurgical and Materials Transactions A, 2011
- The diffraction patterns from β″ precipitates in 12 orientations in Al–Mg–Si alloyScripta Materialia, 2010
- Cu-segregation at the Q′/α-Al interface in Al–Mg–Si–Cu alloyScripta Materialia, 2002
- Metastable phases in an Al-Mg-Si alloy containing copperMetallurgical and Materials Transactions A, 2001
- Precipitation in aluminum alloys AA6111 and AA6016Scripta Materialia, 1999
- The crystal structure of the β″ phase in Al–Mg–Si alloysActa Materialia, 1998