Heat Generation During Bone Drilling: A Comparison Between Industrial and Orthopaedic Drill Bits
Authors:
- 1 February 2017
- journal article
- research article
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 31 (2) , e55-e59
Abstract
Objectives: Cortical bone drilling for preparation of screw placement is common in multiple surgical fields. The heat generated while drilling may reach thresholds high enough to cause osteonecrosis. This can compromise implant stability. Orthopaedic drill bits are several orders more expensive than their similarly sized, publicly available industrial counterparts. We hypothesize that an industrial bit will generate less heat during drilling, and the bits will not generate more heat after multiple cortical passes. Methods: We compared 4 4.0 mm orthopaedic and 1 3.97 mm industrial drill bits. Three types of each bit were drilled into porcine femoral cortices 20 times. The temperature of the bone was measured with thermocouple transducers. The heat generated during the first 5 drill cycles for each bit was compared to the last 5 cycles. These data were analyzed with analysis of covariance. Results: The industrial drill bit generated the smallest mean increase in temperature (2.8 ± 0.29°C) P < 0.0001. No significant difference was identified comparing the first 5 cortices drilled to the last 5 cortices drilled for each bit. The P-values are as follows: Bosch (P = 0.73), Emerge (P = 0.09), Smith & Nephew (P = 0.08), Stryker (P = 0.086), and Synthes (P = 0.16). The industrial bit generated less heat during drilling than its orthopaedic counterparts. The bits maintained their performance after 20 drill cycles. Conclusions: Consideration should be given by manufacturers to design differences that may contribute to a more efficient cutting bit. Further investigation into the reuse of these drill bits may be warranted, as our data suggest their efficiency is maintained after multiple uses.Keywords
This publication has 18 references indexed in Scilit:
- Plunging When DrillingJournal of Orthopaedic Trauma, 2012
- A comparison of the thermal properties of 2- and 3-fluted drills and the effects on bone cell viability and screw pull-out strength in an ovine modelClinical Biomechanics, 2010
- Fatigue strength of common tibial intramedullary nail distal locking screwsJournal of Orthopaedic Surgery and Research, 2009
- Heat Production by 3 Implant Drill Systems After Repeated Drilling and SterilizationJournal of Oral and Maxillofacial Surgery, 2006
- Effects of repeated drill use on temperature of bone during preparation for osteosynthesis self-tapping screwsBritish Journal of Oral and Maxillofacial Surgery, 2005
- Effect of Fixation Pin Insertion on the Bone‐Pin InterfaceVeterinary Surgery, 1986
- The effect of heat on bone regeneration: An experimental study in the rabbit using the bone growth chamberJournal of Oral and Maxillofacial Surgery, 1984
- Thermally Induced Bone Necrosis in RabbitsClinical Orthopaedics and Related Research, 1984
- Heat caused by drilling cortical bone: Temperature measuredin vivoin patients and animalsActa Orthopaedica, 1984
- The temperature dependence of the deformation of boneJournal of Biomechanics, 1968