Non-basal slip in sapphire
Authors:
- 1 September 1973
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 28 (3) , 623-637
Abstract
The plastic deformation of sapphire by mechanisms other than slip on the basal plane has been studied by bending crystals of orientations such that extension and contraction normal to the basal plane (0° specimens) or parallel to the basal plane (90° specimens) are required. 0° specimens could not be plastically bent below 1600° C. Above 1600° C there was extensive plasticity but no single slip system could be identified. 90° specimens could be plastically bent by the operation of the slip system at temperatures as low as 1150°C. The temperature dependences and strain rate sensitivities of the flow stresses for 0° and 90° have been determined. There are striking differences between the characteristics of the two types of deformation, which are attributed to the fact that different dislocations are involved.Keywords
This publication has 18 references indexed in Scilit:
- Prismatic Slip in SapphireJournal of the American Ceramic Society, 1972
- Plastic Deformation of Aluminum Oxide by Indentation and AbrasionJournal of the American Ceramic Society, 1971
- Plastic Deformation of Corundum Single CrystalsPhysica Status Solidi (b), 1970
- Direct Observation of Nonbasal Dislocations in Sintered AluminaJournal of the American Ceramic Society, 1967
- A new slip system in sapphireJournal of Materials Science, 1967
- Deformation twinning in corundumPhilosophical Magazine, 1966
- Mechanical Behavior of SamhireJournal of the American Ceramic Society, 1965
- Dynamical Flow Properties of Single Crystals of Sapphire, IJournal of the American Ceramic Society, 1962
- Climb of Dislocations in Magnesium OxideJournal of Applied Physics, 1962
- Creep of Al2O3 Single CrystalsJournal of Applied Physics, 1960