Load–Pull Wideband Class-E Amplifier
Author:
- 5 March 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 17 (3) , 235-237
Abstract
A new technique to design wideband Class-E power amplifiers (PAs) based on the synthesis of specific load admittances at fundamental and harmonics is shown. This technique symplifies the design of wideband Class-E amplifiers by making it independent on any specific load network, implementation, and intrinsic transistor output capacitance COUT. Simulations and actual measurements on a 15-W VHF wideband Class-E PA prototype designed using this method show 35% fractional bandwidth with 80% drain efficiencyKeywords
This publication has 8 references indexed in Scilit:
- Design of low-cost broadband class-E power amplifier using low-voltage supplyMicrowave and Optical Technology Letters, 2004
- New driver for high‐efficiency switching RF power amplifiersMicrowave and Optical Technology Letters, 2004
- Broadband high-efficiency monolithic InGaP/GaAs HBT power amplifiers for wireless applicationsInternational Journal of RF and Microwave Computer-Aided Engineering, 2003
- Class-E switching-mode high-efficiency tuned RF/microwave power amplifier: improved design equations2002
- Class-E, Class-C, and Class-F power amplifiers based upon a finite number of harmonicsIEEE Transactions on Microwave Theory and Techniques, 2001
- High-efficiency load-pull harmonic controlled Class-E power amplifierIEEE Microwave and Guided Wave Letters, 1998
- The transmission-line high-efficiency class-E amplifierIEEE Microwave and Guided Wave Letters, 1995
- Broadband power efficient Class E amplifiers with a non-linear CAD model of the active MOS deviceJournal of the Institution of Electronic and Radio Engineers, 1987