Thermal Fluid-Structure Interaction in the Effects of Pin-Through-Hole Diameter during Wave Soldering
Open Access
- 1 January 2014
- journal article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 6
Abstract
An effective simulation approach is introduced in this paper to study the thermal fluid-structure interaction (thermal FSI) on the effect of pin-through-hole (PTH) diameter on the wave soldering zone. A 3D single PTH connector and a printed circuit board model were constructed to investigate the capillary flow behavior when passing through molten solder (63SnPb37). In the analysis, the fluid solver FLUENT was used to solve and track the molten solder advancement using the volume of fluid technique. The structural solver ABAQUS was used to examine the von Mises stress and displacement of the PTH connector in the wave soldering process. Both solvers were coupled by MpCCI software. The effects of six different diameter ratios (0.1 < d/D < 0.97) were studied through a simulation modeling. The use of ratio d/D = 0.2 yielded a balanced filling profile and low thermal stress. Results revealed that filling level, temperature, and displacement exhibited polynomial behavior to d/D. Stress of pin varied quadratically with the d/D. The predicted molten solder profile was validated by experimental results. The simulation results are expected to provide better visualization and understanding of the wave soldering process by considering the aspects of thermal FSI.Keywords
Funding Information
- Ministry of Higher Education, Malaysia
- Universiti Malaysia Kelantan
This publication has 21 references indexed in Scilit:
- Optimization of IC encapsulation considering fluid/structure interaction using response surface methodologySimulation Modelling Practice and Theory, 2012
- Application of flexible printed circuit board (FPCB) in personal computer motherboards: Focusing on mechanical performanceMicroelectronics Reliability, 2012
- Influence of Gap Height in Flip Chip Underfill Process With Non-Newtonian Flow Between Two Parallel PlatesJournal of Electronic Packaging, 2012
- Investigation of the fluid/structure interaction phenomenon in IC packagingMicroelectronics Reliability, 2012
- Study on the fluid/structure interaction at different inlet pressures in molded packagingMicroelectronic Engineering, 2011
- IMMERSED BOUNDARY METHODSAnnual Review of Fluid Mechanics, 2005
- A moving frame of reference algorithm for fluid/structure interaction of rotating and translating bodiesInternational Journal for Numerical Methods in Fluids, 2001
- An Immersed-Boundary Finite-Volume Method for Simulations of Flow in Complex GeometriesJournal of Computational Physics, 2001
- Prediction of paddle shift via 3-D TSOP modelingIEEE Transactions on Components and Packaging Technologies, 2000
- A direct numerical simulation study of flow past a freely vibrating cableJournal of Fluid Mechanics, 1997