Effect of Ultrasonic Impact Treatment on the Stress Corrosion Cracking of 304 Stainless Steel Welded Joints
- 3 September 2009
- journal article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 131 (5) , 051502
Abstract
High tensile weld residual stress is an important factor contributing to stress corrosion cracking (SCC). Ultrasonic impact treatment (UIT) can produce compressive stresses on the surface of welded joints that negate the tensile stresses to enhance the SCC resistance of welded joints. In the present work, X-ray diffraction method was used to obtain the distribution of residual stress induced by UIT. The results showed that UIT could cause a large compressive residual stress in access of 300 MPa on the surface of the material. A 3D finite element model was established to simulate the UIT process by using the finite element software ABAQUS. The residual stress distribution of the AISI 304 stainless steel induced by UIT was predicted by finite element analysis. In order to demonstrate the improvement of the SCC resistance of the welded joints, the specimens were immersed in boiling 42% magnesium chloride solution during SCC testing, and untreated specimen cracked after immersion for 23 h. In contrast, treated specimens with different impact duration were tested for 1000 h without visible stress corrosion cracks. The microstructure observation results revealed that a hardened layer was formed on the surface and the initial coarse-grained structure in the surface was refined into ultrafine grains. The above results indicate that UIT is an effective approach for protecting weldments against SCC.Keywords
This publication has 7 references indexed in Scilit:
- Effect of Nozzle-Traveling Velocity on Oil Cavitation Jet Peening of Aluminum Alloy, AA 6063-T6Journal of Engineering Materials and Technology, 2007
- Physics and mechanism of ultrasonic impactUltrasonics, 2006
- Assessment of Tensile Residual Stress Mitigation in Alloy 22 Welds Due to Laser PeeningJournal of Engineering Materials and Technology, 2004
- The investigation of internal friction and elastic modulus in surface nanostructured materialsMaterials Science and Engineering: A, 2004
- Residual stress modification by post-weld treatment and its beneficial effect on fatigue strength of welded structuresInternational Journal of Fatigue, 2003
- Effects of Shot-Peening on Fretting-Fatigue Behavior of Ti-6Al-4VJournal of Engineering Materials and Technology, 2002
- Surface nanocrystallization of 316L stainless steel induced by ultrasonic shot peeningMaterials Science and Engineering: A, 2000