Design and testing of 45 kV, 50 kHz pulse power supply for dielectric barrier discharges
- 1 October 2016
- journal article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 87 (10) , 105115
Abstract
The design, construction, and testing of high frequency, high voltage pulse power supply are reported. The purpose of the power supply is to generate dielectric barrier discharges for industrial applications. The power supply is compact and has the advantage of low cost, over current protection, and convenient control for voltage and frequency selection. The power supply can generate high voltage pulses of up to 45 kV at the repetitive frequency range of 1 kHz–50 kHz with 1.2 kW input power. The output current of the power supply is limited to 500 mA. The pulse rise time and fall time are less than 2 μs and the pulse width is 2 μs. The power supply is short circuit proof and can withstand variable plasma load conditions. The power supply mainly consists of a half bridge series resonant converter to charge an intermediate capacitor, which discharges through a step-up transformer at high frequency to generate high voltage pulses. Semiconductor switches and amorphous cores are used for power modulation at higher frequencies. The power supply is tested with quartz tube dielectric barrier discharge load and worked stably. The design details and the performance of the power supply on no load and dielectric barrier discharge load are presented.Keywords
This publication has 23 references indexed in Scilit:
- Plasma Apparatuses for Biomedical ApplicationsIEEE Transactions on Plasma Science, 2015
- Removal of priority pollutants from water by means of dielectric barrier discharge atmospheric plasmaJournal of Hazardous Materials, 2013
- Carbamazepine removal from water by dielectric barrier discharge: Comparison of ex situ and in situ discharge on waterChemical Engineering and Processing - Process Intensification, 2012
- DBD reactor instrumentation for NOxdegradationThe European Physical Journal Applied Physics, 2011
- Campus PlasmaMed—From Basic Research to Clinical ProofIEEE Transactions on Plasma Science, 2011
- Ozone generation using atmospheric pressure glow discharge in airJournal of Physics D: Applied Physics, 2009
- Dielectric barrier discharge source for supersonic beamsReview of Scientific Instruments, 2009
- Development of dielectric barrier discharge plasma processing apparatus for mass spectrometry and thin film depositionReview of Scientific Instruments, 2007
- "On the ionization of air for removal of noxious effluvia" (Air ionization of indoor environments for control of volatile and particulate contaminants with nonthermal plasmas generated by dielectric-barrier discharge)IEEE Transactions on Plasma Science, 2002
- Dielectric-Barrier Discharges. Principle and ApplicationsJournal de Physique IV, 1997