Flatness-Based Loss Optimization and Control of a Doubly Fed Induction Generator System
Authors:
- 23 December 2010
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 19 (6) , 1457-1466
Abstract
An electrical power circuit consisting of a doubly fed induction generator and two power-electronic converters is considered. A mathematical model is given, and the flatness of the model is shown. The freedom in the choice of one component of the flat output chosen is used in order to minimize the power losses in the system. Trajectory tracking controllers for the machine and the grid side converter are developed using a backstepping approach. The results are supported by numerical simulations.Keywords
This publication has 18 references indexed in Scilit:
- High-performance control of a three-phase voltage-source converter including feedforward compensation of the estimated load currentEnergy Conversion and Management, 2009
- Flatness-based control of the separately excited DC drive2007
- Introduction2007
- Loss reduction methods for doubly-fed induction generator drives for wind turbines2006
- Rekursiver Entwurf stabiler Regelkreise durch sukzessive Berücksichtigung von Integratoren und quasi-statische Rückführungen (Recursive Design of Stable Control Loops by Integrator Backstepping and Quasi-static Feedback)at - Automatisierungstechnik, 2005
- Invariant trackingESAIM: Control, Optimisation and Calculus of Variations, 2004
- Doubly Fed Induction Generator Systems for Wind Turbines: A Viable Alternative to Adjust Speed over a Wide Range at Minimal CostIEEE Industry Applications Magazine, 2002
- Control of flat systems by quasi-static feedback of generalized statesInternational Journal of Control, 1998
- A flexible active and reactive power control strategy for a variable speed constant frequency generating systemIEEE Transactions on Power Electronics, 1995
- Flatness and defect of non-linear systems: introductory theory and examplesInternational Journal of Control, 1995