EDIPO: The Test Facility for High-Current High-Field HTS Superconductors
Authors:
- Pierluigi BruzzonePBPierluigi Bruzzone
- Boris StepanovBSBoris Stepanov
- Davide UgliettiDUDavide Uglietti
- Rainer WescheRWRainer Wesche
- Kamil SedlakKSKamil Sedlak
- 17 November 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 26 (2) , 35-40
Abstract
The commissioning of the European DIPOle (EDIPO) test facility at the Center for Research in Plasma Physics in Villigen was completed in Spring 2015, and the first test of a 60-kA/12-T high-temperature superconductor (HTS) was carried out in June 2015. User specifications are issued to allow external users to prepare their own sample matching the interface of the test facility. EDIPO offers a background magnetic field up to 12.35 T in a rectangular test well with a cross section of 89 mm × 138 mm (sample dimension). The homogeneous high field length is 910 mm (±1%) or 680 mm (±0.5%) at full current. A set of small copper coils provides a superimposed ac field with amplitude up to ±0.3 T and frequency up to 1 Hz. A superconducting transformer provides steady-state operating current for the sample up to 100 kA. The cooling circuit of the sample supplies supercritical helium at 10-bar inlet pressure. The mass flow rate, which is adjustable by cryogenic valves, is up to 8 g/s in each branch of the sample at 4.5 K. The operating temperature ranges from 4.5 to 60 K (at high temperature, the range of mass flow rate is reduced). To test samples at temperature higher than 10 K, an HTS “adapter” connects the sample to the NbTi transformer plates, which must remain cold. In such case, the length of the sample is reduced from 3600 mm (typical low-temperature superconductor sample) to 2900 mm (HTS sample with adapter).Keywords
This publication has 10 references indexed in Scilit:
- Completion of the Commissioning of the EDIPO Test FacilityIEEE Transactions on Applied Superconductivity, 2015
- Commissioning of the Main Coil of the EDIPO Test FacilityIEEE Transactions on Applied Superconductivity, 2013
- The EDIPO Project: Status and OutlookIEEE Transactions on Applied Superconductivity, 2011
- Test results of the 18kA EDIPO HTS current leadsFusion Engineering and Design, 2011
- Status Report of the EDIPO ProjectIEEE Transactions on Applied Superconductivity, 2010
- Development of the EFDA Dipole High Field ConductorIEEE Transactions on Applied Superconductivity, 2008
- Preparatory Work to Host the EDIPO Test Facility at CRPPIEEE Transactions on Applied Superconductivity, 2008
- Conceptual Design of the 12.5 T Superconducting EFDA DipoleIEEE Transactions on Applied Superconductivity, 2006
- Design and optimization of the 12.5T EFDA dipole magnetCryogenics, 2006
- Upgrade of operating range for SULTAN test facilityIEEE Transactions on Applied Superconductivity, 2002