Fault modeling and mapping for quantum-dot cellular automata (QCA) designs
Authors:
- 1 December 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 431-435
Abstract
This paper addresses the issue of fault modeling and mapping between a design done at the CMOS gate-level and one done using QCA technology. Since QCA and CMOS gate-level defects differ completely, it is important to investigate the mapping between classical single stuck-at fault (SSF) modeling and QCA defect and failure modes. This paper suggests a methodology in which fault modeling for a QCA circuit can be inferred from the SSF modeling of its CMOS gate-level representation. Cadence NCLaunch was used for SSF modeling while QCADesigner was used for QCA circuit simulation and fault modeling.Keywords
This publication has 11 references indexed in Scilit:
- Design rules for Quantum-dot Cellular Automata2011
- Adder and Multiplier Design in Quantum-Dot Cellular AutomataIEEE Transactions on Computers, 2009
- A Test Generation Framework for Quantum Cellular Automata CircuitsIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2007
- HDLQACM Journal on Emerging Technologies in Computing Systems, 2006
- Design Tools for an Emerging SoC Technology: Quantum-Dot Cellular AutomataProceedings of the IEEE, 2006
- Complex gate implementations for quantum dot cellular automata2005
- Testing of Quantum Cellular AutomataIEEE Transactions on Nanotechnology, 2004
- Incorporating Standard CMOS Design Process Methodologies into the QCA Logic Design ProcessIEEE Transactions on Nanotechnology, 2004
- Power gain and dissipation in quantum-dot cellular automataJournal of Applied Physics, 2002
- Faulty behavior of storage elements and its effects on sequential circuitsIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 1993