Metal additive manufacturing enables the production of complex Ti-6Al-4V components, but internal defects may form during processing and remain difficult to detect by visual inspection. This paper presents an automated acoustic tap-testing system for repeatable non-destructive evaluation of additively manufactured Ti-6Al-4V specimens. The system combines controlled mechanical excitation, longitudinal positioning, specimen rotation and elevation, soft mechanical isolation, and contact-free acoustic measurement to acquire consistent resonance-based responses. Candidate support materials were evaluated to approximate free-free boundary conditions, and finite-element modal simulations were used to relate measured spectral peaks to elastic vibration modes and support system calibration. Experimental verification showed dominant resonance bands around 4 kHz and 12.5 kHz, consistent with the adjusted modal simulation. A repeatability test on 40 specimens showed stable acoustic energy levels of approximately 109–115 dB, with no signal saturation. These results demonstrate that the developed platform reduces operator dependence, enables repeatable acoustic data acquisition, and provides a controlled basis for future classification of internal defects in additively manufactured metal components.