Theoretical and Experimental Study of 3-Pentanol Autoignition: Ab Initio Calculation, Shock Tube Experiments, and Kinetic Modeling
Authors:
- 2 July 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 125 (27) , 5976-5989
Abstract
3-Pentanol is a potential alternative fuel or a green fuel additive for modern engines. The H-abstraction reactions from 3-pentanol by H, CH3, HO2, and OH radicals are significant in the 3-pentanol oxidation process. However, corresponding rate constants are forced to rely on either analogy from sec-butanol or estimation from alkanes due to a lack of direct experimental and theoretical study. In this work, stationary points on the potential energy surfaces (PESs) were calculated with the high-level DLPNO-CCSD(T)/CBS(T-Q)//M06-2X/cc-pVTZ method, which is further used to benchmark against the CBS-QB3 method. Then, the high-pressure limit rate constants for target reactions, over a broad range of temperature (400–2000 K), were calculated with the phase-space theory and conventional transition state theory. A comparison was made between the calculated rate constants and the values available in Carbonnier et al. [ Proc. Combust. Inst. 2019, 37(1), 477−484]. The rate constants for the above H-abstraction reactions in the Carbonnier model were updated with the calculated results, followed by a modification based on the computed results of 3-pentanol + HO2 to obtain the revised model. Validation against the shock tube (ST) and the jet-stirred reactor (JSR) measurements from the literature proved the revised model an optimal one. Furthermore, using an ST, ignition delay times (IDTs) for the 3-pentanol/air mixtures were measured spanning a temperature range of 920–1450 K, pressures of 6, 10, and 20 bar, and equivalence ratios of 0.5, 1.0, and 1.5. Generally, IDTs decrease with increasing temperature and reflected shock pressure. Improved predictions to present experimental data were obtained by using the revised model as compared with the Carbonnier model. Finally, sensitivity analysis was conducted using the revised model to gain an in-depth comprehension of the 3-pentanol autoignition.Keywords
Funding Information
- National Natural Science Foundation of China (51425602, 51961135105)
This publication has 57 references indexed in Scilit:
- Assessment of ultra-lean burn characteristics for a stratified-charge direct-injection spark-ignition methanol engine under different high compression ratiosApplied Energy, 2020
- Experimental study of the spray, combustion, and emission performance of a diesel engine with high n-pentanol blending ratiosEnergy Conversion and Management, 2019
- Co-effects of fuel research octane number and ethanol injection ratio on dual-fuel spark-ignition engineInternational Journal of Engine Research, 2019
- Combustion and regulated/unregulated emissions of a direct injection spark ignition engine fueled with C3-C5 alcohol/gasoline surrogate blendsEnergy, 2019
- Chemical Kinetics of H-Atom Abstraction from Ethanol by HȮ2: Implication for Combustion ModelingThe Journal of Physical Chemistry A, 2019
- Autoignition of ethanol in a rapid compression machineCombustion and Flame, 2014
- Experimental investigation of the laminar burning velocities of methanol, ethanol, n-propanol, and n-butanol at high pressureFuel, 2014
- Lignocellulosic biomass for bioethanol production: Current perspectives, potential issues and future prospectsProgress in Energy and Combustion Science, 2012
- Pentanol isomer synthesis in engineered microorganismsApplied Microbiology and Biotechnology, 2009
- Expanding metabolism for biosynthesis of nonnatural alcoholsProceedings of the National Academy of Sciences, 2008