Examining the Quasi-Static Uniaxial Compressive Behaviour of Commercial High-Performance Epoxy Matrices
Open Access
Abstract
Four commercial high-performance aerospace aromatic epoxy matrices, CYCOM®890, CYCOM®977-2, PR520, and PRISM EP2400, were cured to a standardised 2 h, 180 °C cure cycle and evaluated in quasi-static uniaxial compression, as well as by dynamic scanning calorimetry (DSC) and thermogravimetric analysis (TGA). The thermoplastic toughened CYCOM®977-2 formulation displayed an overall increase in true axial stress values across the entire stress–strain curve relative to the baseline CYCOM®890 sample. The particle-toughened PR520 sample exhibited an overall decrease in true axial stress values past the yield point of the material. The PRISM EP2400 resin, with combined toughening agents, led to true axial stress values across the entire plastic region of the stress–strain curve, which were in line with the stress values observed with the CYCOM®890 material. Interestingly, for all formulations, the dilation angles (associated with the volume change during plastic deformation), recorded at 0.3 plastic strain, were close to 0°, with the variations reflecting the polymer structure. Compression data collected for this series of commercial epoxy resins are in broad agreement with a selection of model epoxy resins based on di- and tetra-functional monomers, cured with polyamines or dicarboxylic anhydrides. However, the fully formulated resins demonstrate a significantly higher compressive modulus than the model resins, albeit at the expense of yield stress.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/T011653/1)
This publication has 31 references indexed in Scilit:
- The mechanisms and mechanics of the toughening of epoxy polymers modified with silica nanoparticlesPolymer, 2010
- Structure–property relations of 55 nm particle-toughened epoxyPolymer, 2010
- Effect of silica nanoparticles on compressive properties of an epoxy polymerJournal of Materials Science, 2010
- Uniaxial compression testing of polymeric materialsPolymer Testing, 2010
- UHMWPE as interface toughening agent in glass particle filled compositesComposites Part A: Applied Science and Manufacturing, 2006
- Influence of temperature and strain rate on the mechanical behavior of three amorphous polymers: Characterization and modeling of the compressive yield stressInternational Journal of Solids and Structures, 2006
- Considerations of the dilatancy angle in rocks and rock massesInternational Journal of Rock Mechanics and Mining Sciences, 2005
- Angles of friction and dilatancy of sandGéotechnique, 1996
- Mechanisms of Toughening Thermoset Resins1993
- Barreling of Solid Cylinders Under Axial CompressionJournal of Engineering Materials and Technology, 1985