Model validation of mechanical face seals in two-phase flow conditions
Authors:
- M. GaniMGM. Gani
- I.F. SantosISI.F. Santos
- M. ArghirMAM. Arghir
- H. GrannHGH. Grann
Open Access
- 1 March 2022
- journal article
- research article
- Published by Elsevier in Tribology International
- Vol. 167
Abstract
No abstract availableKeywords
Funding Information
- Innovationsfonden (8053-00202B)
This publication has 13 references indexed in Scilit:
- Thermogas- and thermohydrodynamic simulation of thrust and slider bearings: Convergence and efficiency of different reduction approachesTribology International, 2016
- Study of the fluid film vaporization in the interface of a mechanical face sealTribology International, 2015
- Non-isothermal performance characteristics of fluidfilm mechanical face sealsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2001
- Vaporization in Face Seals Operating with Liquid MixturesTribology Transactions, 1997
- Expressions for the Viscosity of Liquid/Vapour Mixtures: Predicted and Measured Pressure Distributions in a Hydrostatic BearingProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 1996
- A Continuous Boiling Model for Face SealsJournal of Tribology, 1990
- A Simplified Model for Two Phase Face Seal DesignTribology Transactions, 1990
- A Mixed Friction Hydrostatic Face Seal Model With Phase ChangeJournal of Lubrication Technology, 1980
- Phase Change in Liquid Face SealsJournal of Lubrication Technology, 1978
- Measurements of convective heat transfer from a horizontal cylinder rotating in a tank of waterInternational Journal of Heat and Mass Transfer, 1963