Discharge Coefficient Measurements of Film-Cooling Holes With Expanded Exits
Authors:
- 1 July 1998
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 120 (3) , 557-563
Abstract
This paper presents the discharge coefficients of three film-cooling hole geometries tested over a wide range of flow conditions. The hole geometries include a cylindrical hole and two holes with a diffuser-shaped exit portion (i.e., a fan-shaped and a laidback fan-shaped hole). The flow conditions considered were the crossflow Mach number at the hole entrance side (up to 0.6), the crossflow Mach number at the hole exit side (up to 1.2), and the pressure ratio across the hole (up to 2). The results show that the discharge coefficient for all geometries tested strongly depends on the flow conditions (crossflows at hole inlet and exit, and pressure ratio). The discharge coefficient of both expanded holes was found to be higher than of the cylindrical hole, particularly at low pressure ratios and with a hole entrance side crossflow applied. The effect of the additional layback on the discharge coefficient is negligible.Keywords
This publication has 17 references indexed in Scilit:
- Adiabatic Wall Effectiveness Measurements of Film-Cooling Holes With Expanded ExitsJournal of Turbomachinery, 1998
- Flowfield Measurements for Film-Cooling Holes With Expanded ExitsJournal of Turbomachinery, 1998
- Discharge Coefficient of Turbine Cooling Holes: A ReviewJournal of Turbomachinery, 1998
- Film Cooling With Compound Angle Holes: Adiabatic EffectivenessJournal of Turbomachinery, 1996
- Film Cooling With Compound Angle Holes: Heat TransferJournal of Turbomachinery, 1996
- Discharge Coefficients of Holes Angled to the Flow DirectionJournal of Turbomachinery, 1994
- Aerodynamic Loss Penalty Produced by Film Cooling Transonic Turbine BladesJournal of Engineering for Gas Turbines and Power, 1984
- Effect of Crossflows on the Discharge Coefficient of Film Cooling HolesJournal of Engineering for Power, 1983
- Effects of hole geometry and density on three-dimensional film coolingInternational Journal of Heat and Mass Transfer, 1974
- Discharge Coefficients for Incompressible Non-Cavitating Flow through Long OrificesJournal of Mechanical Engineering Science, 1965