Discharge estimation combining flow routing and occasional measurements of velocity
Open Access
- 26 September 2011
- journal article
- Published by Copernicus GmbH in Hydrology and Earth System Sciences
- Vol. 15 (9) , 2979-2994
Abstract
A new procedure is proposed for estimating river discharge hydrographs during flood events, using only water level data at a single gauged site, as well as 1-D shallow water modelling and occasional maximum surface flow velocity measurements. One-dimensional diffusive hydraulic model is used for routing the recorded stage hydrograph in the channel reach considering zero-diffusion downstream boundary condition. Based on synthetic tests concerning a broad prismatic channel, the "suitable" reach length is chosen in order to minimize the effect of the approximated downstream boundary condition on the estimation of the upstream discharge hydrograph. The Manning's roughness coefficient is calibrated by using occasional instantaneous surface velocity measurements during the rising limb of flood that are used to estimate instantaneous discharges by adopting, in the flow area, a two-dimensional velocity distribution model. Several historical events recorded in three gauged sites along the upper Tiber River, wherein reliable rating curves are available, have been used for the validation. The outcomes of the analysis can be summarized as follows: (1) the criterion adopted for selecting the "suitable" channel length based on synthetic test studies has proved to be reliable for field applications to three gauged sites. Indeed, for each event a downstream reach length not more than 500 m is found to be sufficient, for a good performances of the hydraulic model, thereby enabling the drastic reduction of river cross-sections data; (2) the procedure for Manning's roughness coefficient calibration allowed for high performance in discharge estimation just considering the observed water levels and occasional measurements of maximum surface flow velocity during the rising limb of flood. Indeed, errors in the peak discharge magnitude, for the optimal calibration, were found not exceeding 5% for all events observed in the three investigated gauged sections, while the Nash-Sutcliffe efficiency was, on average, greater than 0.95. Therefore, the proposed procedure well lend itself to be applied for: (1) the extrapolation of rating curve over the field of velocity measurements (2) discharge estimations in different cross sections during the same flood event using occasional surface flow velocity measures carried out, for instance, by hand-held radar sensors.Keywords
All Related Versions
This publication has 28 references indexed in Scilit:
- Discharge estimation in open channels by means of water level hydrograph analysisJournal of Hydraulic Research, 2010
- Formulation of the Entropy Parameter Based on Hydraulic and Geometric Characteristics of River Cross SectionsJournal of Hydrologic Engineering, 2010
- Using unsteady-state water level data to estimate channel roughness and discharge hydrographAdvances in Water Resources, 2009
- Uncertainty in river discharge observations: a quantitative analysisHydrology and Earth System Sciences, 2009
- Accuracy of Kinematic Wave Approximation for Flood Routing. II. Unsteady AnalysisJournal of Hydrologic Engineering, 2008
- Measuring real-time streamflow using emerging technologies: Radar, hydroacoustics, and the probability conceptJournal of Hydrology, 2008
- Use of radars to monitor stream discharge by noncontact methodsWater Resources Research, 2006
- Dual Multilevel Urban Drainage ModelJournal of Hydraulic Engineering, 2005
- Estimation of Mean Velocity in Natural Channels Based on Chiu’s Velocity Distribution EquationJournal of Hydrologic Engineering, 2004
- Streamflow Measurement1985