Elimination of Burn-in Open-Circuit Voltage Degradation by ZnO Surface Modification in Organic Solar Cells
Authors:
- 31 December 2014
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 7 (3) , 1608-1615
Abstract
Photodegradation of inverted organic solar cells based on ZnO as an electron transport layer (ETL) was studied over short time scales of 5 min and 8 h. Devices with ZnO as ETL reproducibly exhibited a steep loss of open-circuit voltage, VOC, and shunt resistance, RSH, in a matter of minutes upon illumination. Removing the UV-content of illumination minimized VOC loss and impact on the device’s shunting behavior, indicating its role in the loss. Application of an ultrathin layer of Al on ZnO led to almost negligible photoinduced VOC loss up to 8 h of exposure. By applying the fundamental Shockley diode equation, we approximated the VOC loss to be caused by dramatic increases in reverse saturation current I0. We attribute the increased rate of recombination to diminished carrier selectivity at the ZnO/organic interface. Devices with Al modified ZnO ETL demonstrated remarkable RSH (1.4 kΩ cm2 at 1 sun), rectification ratio (106) and reverse saturation current density (2.1 × 10–7 mA/cm2).Keywords
Funding Information
- Science and Engineering Research Council, Agency for Science, Technology and Research (1021700134, 1021700137)
This publication has 48 references indexed in Scilit:
- First principles study of photo-oxidation degradation mechanisms in P3HT for organic solar cellsPhysical Chemistry Chemical Physics, 2014
- Solution-processed small-molecule solar cells: breaking the 10% power conversion efficiencyScientific Reports, 2013
- New Insights into the Mechanisms of Photodegradation/Stabilization of P3HT:PCBM Active Layers Using Poly(3-hexyl-d13-Thiophene)Chemistry of Materials, 2013
- 10.2% Power Conversion Efficiency Polymer Tandem Solar Cells Consisting of Two Identical Sub‐CellsAdvanced Materials, 2013
- A polymer tandem solar cell with 10.6% power conversion efficiencyNature Communications, 2013
- Outlook Brightens for Plastic Solar CellsScience, 2011
- Phase Diagram of P3HT/PCBM Blends and Its Implication for the Stability of MorphologyThe Journal of Physical Chemistry B, 2009
- Lifetimes of organic photovoltaics: Combining chemical and physical characterisation techniques to study degradation mechanismsSolar Energy Materials and Solar Cells, 2006
- Lifetimes of organic photovoltaics: Using TOF-SIMS and 18O2 isotopic labelling to characterise chemical degradation mechanismsSolar Energy Materials and Solar Cells, 2006
- Stability of the interface between indium-tin-oxide and poly(3,4-ethylenedioxythiophene)/poly(styrenesulfonate) in polymer light-emitting diodesApplied Physics Letters, 2000