Formation of Intermetallic Compounds in Friction Bonding of Al Alloys to Steel
Authors:
- 15 March 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 539-543, 3865-3871
Abstract
The microstructure of the friction-bonded interface of Al alloys to low C steel has been investigated by TEM observations to reveal the controlling factor of the formation and growth of the IMC (Intermetallic Compound) layer, which caused the premature fracture at the interface even when its thickness was less than 1 μm, as reported in a previous paper. The thickness of the IMC layer observed at the interfaces of Al-Mg alloy/steel and pure-aluminum/steel joints increased almost in proportion to the friction time, but did not obey the parabolic law a characteristic kinetics of the diffusion-controlled process. Analyses of SAD patterns from the IMC layer indicate that it consisted of Fe2Al5, Fe4Al13, (Fe, Mn)Al6 and FeAl2, depending on the alloying elements. These IMCs were granular and distributed almost randomly within the IMC layer, suggesting that mechanical mixing of the steel with the Al alloy occurred at the interface. In the low C steel adjacent to the IMC layer, a zone of much finer grains than those of the base metal was observed. Its width increased with friction time and pressure, and with the growth of the IMC layer, as well. These results suggest that the superficial region of the steel underwent a heavy plastic deformation during the friction process and it had a close relation with the growth of the IMC layer.Keywords
This publication has 8 references indexed in Scilit:
- Effect of interfacial layer on bond strength of friction-welded interface of Al-Mg5083 alloy to mild steelQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2005
- Effect of Intermetallic Compound Layer on Bond Strength of Friction-welded Interface of Commercially Pure Aluminum to Mild SteelQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2005
- Interface properties of aluminum/steel friction-welded componentsMaterials Characterization, 2002
- Formation process of reaction layer between aluminium alloys and stainless steel by friction weldingWelding International, 2002
- Friction weldability of aluminium alloys to carbon steelWelding International, 2000
- Static joint strength of friction welded joint between aluminium alloys and stainless steelWelding International, 2000
- Friction Welding of Aluminum and Plain Low Carbon Steel.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2000
- Friction weldability of various aluminum alloy pipe to SUS304 stainless steel pipe.Journal of Japan Institute of Light Metals, 1999