Effects of different cutting methods for electrical steel sheets on performance of induction motors
- 29 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 232 (7) , 1287-1294
Abstract
In this study, by cutting electrical steel stator laminations, one of the most important components of electrical machines by different cutting methods, the effects of these cutting methods on motor efficiency are investigated. As cutting methods, wire electrical discharge machining, punching, laser and abrasive water jet methods are used. Burr formation at the cutting edge leads to short circuits during the steel packaging and causes magnetic losses in steel packages to increase. In addition, depending on the cutting methods, electrical steel lamination insulation layer is damaged as a result of residual and thermal stress formations. These negative conditions cause iron, friction and windage, stator, rotor and additional load losses occurred in the engine to decrease. In order to minimize these cases, electrical steel stator laminations are cut with the cutting parameters determined as a result of pre-cut tests and 5.5-kW induction motors are manufactured. These manufactured motors, according to IEC 60034-2-1-1B method, are subjected to no-load performance tests in addition to six different loading ratios of 25%–50%–75%–100%–115%–125% and constant 50 Hz frequency. As a result of the test measurements, losses occurred in electrical steels cut with abrasive water jet are found to be higher than the other cutting methods. In addition, in terms of the motor performance, the best results are obtained with wire electrical discharge machining cutting method.Keywords
Funding Information
- TÜBİTAK (214M610 Project No)
This publication has 28 references indexed in Scilit:
- Mathematical model for cutting effect on magnetic flux distribution near the cut edge of non-oriented electrical steelsComputational Materials Science, 2008
- Effect of waterjet formation on surface preparation and profiling of aluminum alloyWear, 2008
- Influence of shearing process on domain structure and magnetic properties of non-oriented electrical steelJournal of Magnetism and Magnetic Materials, 2006
- Effect of mechanical and Nd:YAG laser cutting on magnetic flux distribution near the cut edge of non-oriented steelsJournal of Materials Processing Technology, 2005
- Influence of abrasive waterjet cutting on the magnetic properties of non-oriented electrical steelsJournal of Magnetism and Magnetic Materials, 2003
- Waterjet and abrasive waterjet surface treatment of titanium: a comparison of surface texture and residual stressWear, 2001
- Effect of punching on electrical steels: Experimental and numerical coupled analysisIEEE Transactions on Magnetics, 2000
- Influence of the cutting process on the magnetic properties of non-oriented electrical steelsJournal of Magnetism and Magnetic Materials, 2000
- A study of abrasive waterjet cutting of metallic coated sheet steelsInternational Journal of Machine Tools and Manufacture, 1999
- ANALYSIS OF SPARK PROFILES DURING EDM PROCESSMachining Science and Technology, 1997