Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery
- 22 July 2017
- journal article
- research article
- Published by Springer Nature in Biomedical Engineering
- Vol. 51 (2) , 106-110
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- The feasibility of producing patient-specific acrylic cranioplasty implants with a low-cost 3D printerJournal of Neurosurgery, 2016
- Maxillary Overdentures Supported by Four Splinted Direct Metal Laser Sintering Implants: A 3-Year Prospective Clinical StudyInternational Journal of Dentistry, 2014
- Direct Metal Laser Sintering Titanium Dental Implants: A Review of the Current LiteratureInternational Journal of Biomaterials, 2014
- Modeling and optimization of direct metal laser sintering processThe International Journal of Advanced Manufacturing Technology, 2014
- Characterization of Metal Powders Used for Additive ManufacturingJournal of Research of the National Institute of Standards and Technology, 2014
- Experimental investigation and empirical modelling of FDM process for compressive strength improvementJournal of Advanced Research, 2012
- Direct metal laser sintering (DMLS) of a customized titanium mesh for prosthetically guided bone regeneration of atrophic maxillary archesMedical & Biological Engineering & Computing, 2011
- Early Human Bone Response to Laser Metal Sintering Surface Topography: A Histologic ReportJournal of Oral Implantology, 2010
- Selective Laser Sintering of Hydroxyapatite Reinforced Polyethylene Composites for Bioactive Implants and Tissue Scaffold DevelopmentProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 2006
- Multi‐objective optimization of part‐ building orientation in stereolithographyRapid Prototyping Journal, 1995