Drag reduction of a slanted-base cylinder using sweeping jets
- 1 October 2022
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (10) , 105101
Abstract
In this work, a pair of sweeping jet actuators is installed underneath the endplate of a slanted-base cylinder at ReD = 200 000. The sweeping jets form a 30° inclined angle with the endplate and are placed at different streamwise locations, and their strength is varied with a momentum coefficient, Cμ, ranging from 3.8 × 10−3 to 6.0 × 10−2. For all the cases examined in this paper, it is found that while a higher Cμ produces a higher drag reduction, the flow control energy efficiency decreases rapidly as Cμ increases. A net energy saving is achieved when Cμ is less than 0.01, and the highest energy efficiency obtained in the present study is 2.8% when the actuator pair is placed at the most upstream location tested. The drag reduction is attributed to the reaction force and an increase in the surface pressure force acting on the endplate produced by the jet pair. The contribution from the former constitutes an increasing proportion of the total drag reduction as Cμ increases leading to lower energy efficiency in flow control. Depending on the relative positions between the trajectory of the sweeping jet and afterbody vortex, sweeping jets are not only capable of altering the surface pressure distributions via directly imposing a footprint of high pressure on the surface, but also affecting the roll-up of the afterbody vortex and/or reducing its strength via injecting turbulence into the afterbody vortex.Keywords
Funding Information
- China Scholarship Council (CSC 201806370001)
This publication has 31 references indexed in Scilit:
- Effect of a Coanda Extension on the Performance of a Sweeping-Jet ActuatorAIAA Journal, 2016
- Flow topology and unsteady features of the wake of a generic high-speed trainJournal of Fluids and Structures, 2016
- Analysis of the Effects of SD Plasma on Aerodynamic Drag Reduction of a High-speed TrainJournal of Electrical Engineering & Technology, 2014
- Optimization of the head shape of the CRH3 high speed trainScience China Technological Sciences, 2010
- Shape optimization of high-speed trains for improved aerodynamic performanceProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2009
- Research into vortex breakdown controlProgress in Aerospace Sciences, 2001
- Reduction of Fuselage Form Drag by Vortex FlowsJournal of Aircraft, 1999
- Interference-free measurements of the subsonic aerodynamics of slanted-base ogive cylindersAIAA Journal, 1991
- Describing the uncertainties in experimental resultsExperimental Thermal and Fluid Science, 1988
- Drag Development of the BelfastAircraft Engineering and Aerospace Technology, 1967