Direct STM Elucidation of the Effects of Atomic-Level Structure on Pt(111) Electrodes for Dissolved CO Oxidation
- 7 January 2013
- journal article
- research article
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 135 (4) , 1476-1490
Abstract
We sought to establish a new standard for direct comparison of electrocatalytic activity with surface structure using in situ scanning tunneling microscopy (STM) by examining the electrooxidation of CO in a CO-saturated solution on Pt(111) electrodes with steps, with combined electrochemical measurements, in situ STM, and density functional theory (DFT). On pristine Pt(111) surfaces with initially disordered (111) steps, CO oxidation commences at least 0.5 V lower than that for the main oxidation peak at ca. 0.8–1.0 V vs the reversible hydrogen electrode in aqueous perchloric acid solution. As the potential was cycled between 0.07 and 0.95 V, the CO oxidation activity gradually decreased until only the main oxidation peak remained. In situ STM showed that the steps became perfectly straight. A plausible reason for the preference for (111) steps in the presence of CO is suggested by DFT calculations. In contrast, on a pristine Pt(111) surface with rather straight (100) steps, the low-potential CO oxidation activity was less than that for the pristine, uncycled (111) steps. As the potential was cycled, the activity also decreased greatly. Interestingly, after cycling, in situ STM showed that (111) microsteps were introduced at the (100) steps. Thus, potential cycling in the presence of dissolved CO highly favors formation of (111) steps. The CO oxidation activity in the low-potential region decreased in the following order: disordered (111) steps > straight (100) steps > (100) steps with local (111) microsteps ≈ straight (111) steps.Keywords
This publication has 139 references indexed in Scilit:
- Pt(111) surface disorder kinetics in perchloric acid solutions and the influence of specific anion adsorptionElectrochimica Acta, 2012
- Kinetic study of CO oxidation on step decorated Pt(111) vicinal single crystal electrodesElectrochimica Acta, 2011
- Oxygen-Enhanced Dissolution of Platinum in Acidic Electrochemical EnvironmentsThe Journal of Physical Chemistry C, 2011
- Interactions between interfacial water and CO adsorbed on Pt and Pt–Ru alloy surfaces under electrochemical conditions: Density-functional theory studyElectrochimica Acta, 2010
- Dynamics of Double-Layer Restructuring on a Platinum Electrode covered by CO: Laser-Induced Potential Transient MeasurementThe Journal of Physical Chemistry C, 2008
- Bulk CO oxidation on platinum electrodes vicinal to the Pt(111) surfaceJournal of Solid State Electrochemistry, 2007
- Imaging Adsorbate O−H Bond Cleavage: Methanol on TiO2(110)Journal of the American Chemical Society, 2006
- Field-Dependent Chemisorption of Carbon Monoxide on Platinum-Group (111) Surfaces: Relationships between Binding Energetics, Geometries, and Vibrational Properties as Assessed by Density Functional TheoryThe Journal of Physical Chemistry B, 2001
- In Situ Infrared Study of Carbon Monoxide Adsorbed onto Commercial Fuel-Cell-Grade Carbon-Supported Platinum Nanoparticles: Correlation with13C NMR ResultsThe Journal of Physical Chemistry B, 2000
- Synthesis and characterization of tetrakis(carbonyl)platinum(II) hexakis(fluorosulfato)platinate(IV), [Pt(CO)4][Pt(SO3F)6]Inorganic Chemistry, 1993