Elastic properties of additively manufactured steel produced with different scan strategies
Authors:
- O. ZinovievaOZO. Zinovieva
- V. RomanovaVRV. Romanova
- A. ZinovievAZA. Zinoviev
- O. NekhoroshevaONO. Nekhorosheva
- R. BalokhonovRBR. Balokhonov
- 28 December 2022
- journal article
- research article
- Published by Elsevier in International Journal of Mechanical Sciences
- Vol. 244
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Science and Higher Education of the Russian Federation
- Siberian Branch, Russian Academy of Sciences (FWRW-2021–0002)
This publication has 78 references indexed in Scilit:
- Solidification behavior in three-phase region of AISI 304 stainless steelMaterials Letters, 2013
- Calculating anisotropic physical properties from texture data using the MTEX open-source packageGeological Society, London, Special Publications, 2011
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010
- Advances in Studies and Applications of Centroidal Voronoi TessellationsNumerical Mathematics: Theory, Methods and Applications, 2010
- Influence of the Crystallographic and the Morphological Texture on the Elastic Properties of Fcc Crystal AggregatesSolid State Phenomena, 2010
- Gradient single-crystal plasticity with free energy dependent on dislocation densitiesJournal of the Mechanics and Physics of Solids, 2007
- A model of solidification microstructures in nickel-based superalloys: predicting primary dendrite spacing selectionActa Materialia, 2003
- Microstructure and texture evolution during solidification processing of Ti–6Al–4VJournal of Materials Processing Technology, 2003
- Probabilistic modelling of microstructure formation in solidification processesActa Metallurgica et Materialia, 1993
- The Elastic Behaviour of a Crystalline AggregateProceedings of the Physical Society. Section A, 1952