Characterising the influence of milk fat towards an application for extrusion-based 3D-printing of casein−whey protein suspensions via the pH−temperature-route
Authors:
- Kilian DaffnerKDKilian Daffner
- Lydia OngLOLydia Ong
- Eric HanssenEHEric Hanssen
- Sally GrasSGSally Gras
- Tom MillsTMTom Mills
- 1 September 2021
- journal article
- research article
- Published by Elsevier in Food Hydrocolloids
- Vol. 118
Abstract
No abstract availableKeywords
Funding Information
- Engineering and Physical Sciences Research Council
This publication has 32 references indexed in Scilit:
- Food Layered Manufacture: A new process for constructing solid foodsTrends in Food Science & Technology, 2012
- Lipid rafts in the bovine milk fat globule membrane revealed by the lateral segregation of phospholipids and heterogeneous distribution of glycoproteinsFood Chemistry, 2010
- The Effect of Milk Processing on the Microstructure of the Milk Fat Globule and Rennet Induced Gel Observed Using Confocal Laser Scanning MicroscopyJournal of Food Science, 2010
- Changes in the surface protein of the fat globules during homogenization and heat treatment of concentrated milkJournal of Dairy Research, 2008
- Protein-stabilized emulsionsCurrent Opinion in Colloid & Interface Science, 2004
- Appearance of submicronic particles in the milk fat globule size distribution upon mechanical treatmentsLe Lait, 2002
- Heat-Induced, pH-Dependent Dissociation of Casein Micelles on Heating Reconstituted Skim Milk at Temperatures below 100 °CJournal of Agricultural and Food Chemistry, 1997
- Composition and Structure of Fat Globule Surface Layers in Recombined MilkJournal of Food Science, 1996
- Interactions between milk serum proteins and synthetic fat globule membrane during heating of homogenized whole milkJournal of Agricultural and Food Chemistry, 1993
- Influence of concentration of milk solids on the dissociation of micellar κ-casein on heating reconstituted milk at 120°CJournal of Dairy Research, 1991