Molecule diffusion behaviours of waterproof sealants into silicone rubber insulation for submarine cable joint based on molecular dynamics simulations
Open Access
- 15 December 2020
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in High Voltage
- Vol. 6 (2) , 230-241
Abstract
The repair joints of high‐voltage cables play a significant role in the urgent cable maintenance, by recovering cable conductor, insulation, shielding layer and waterproof layer especially for submarine cables. However, the molecule diffusion and permeation processes from waterproof sealant into the cable joint insulation occur, leading to the insulation ageing and deterioration. In this article, the molecule diffusion behaviours of six typical molecules from the asphalt‐based and polyurethane‐based waterproof sealants into silicone rubber insulation are investigated. The results show that the order of diffusion coefficients is as follows, phenanthrene > fluoranthene > pyrene > benzo [k] fluoranthene > indeno [1,2,3‐cd] pyrene > polyurethane (PU). The relative molecular mass and binding energy are pivotal factors affecting the diffusion behaviour, while there is a linear relationship between the logarithm of the diffusion coefficient and the ratio of binding energy to relative molecular mass. Besides, the rising ambient temperature increases the fraction of free volume of silicone rubber and decreases the binding energy, thus resulting in a higher diffusion coefficient and an enhanced permeation process of the asphalt‐based sealant. In summary, the PU‐based waterproof sealant, with a much lower permeability than the asphalt‐based material, has a potential application in the waterproof layer for high‐voltage submarine cable repair joints.Keywords
This publication has 29 references indexed in Scilit:
- Critical Review and Recommended Values for the Physical-Chemical Property Data of 15 Polycyclic Aromatic Hydrocarbons at 25 °CJournal of Chemical & Engineering Data, 2009
- Free volume fraction and nanoholes shapes in polyvinyl acetateChemical Physics Letters, 2009
- Physical and Chemical Characterization of Asphalt (Bitumen) Paving ExposuresJournal of Occupational and Environmental Hygiene, 2007
- Determination of the infinite dilution diffusion and activity coefficients of alkanes in polypropylene by inverse gas chromatographyJournal of Applied Polymer Science, 2006
- Calculation of diffusion coefficients for carbon dioxide + solute system near the critical conditions by non-equilibrium molecular dynamics simulationFluid Phase Equilibria, 2004
- Silicon self-diffusion constants by tight-binding molecular dynamicsPhysical Review B, 2001
- Understanding Modern Molecular Dynamics: Techniques and ApplicationsThe Journal of Physical Chemistry B, 1999
- Dynamic Monte Carlo Simulations of Diffusion in Li y Mn2 O 4Journal of the Electrochemical Society, 1999
- A molecular dynamics method for simulations in the canonical ensembleMolecular Physics, 1984
- A computer simulation method for the calculation of equilibrium constants for the formation of physical clusters of molecules: Application to small water clustersThe Journal of Chemical Physics, 1982