Fretting Wear Characteristics of SLM-Formed 316L Stainless Steel in Seawater
Open Access
- 26 December 2022
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 11 (1) , 7
Abstract
The fretting wear characteristics of two different energy density 316L stainless steels formed by selective laser melting (SLM) under different friction conditions are studied. The image method was used to study the porosity of two samples with different energy densities (46.88 J/mm3, 98.96 J/mm3) formed by SLM. The dynamic wear test, respectively, evaluates its wear morphology and wear depth under three conditions: dry friction, distilled water, and an 3.5% NaCl solution. The porosity of the samples with SLM forming an energy density of 46.88 J/ and 98.96 J/ are 7.66% and 1.00%, respectively. Under the three conditions, the friction coefficient and wear depth of the samples with high energy density are smaller than those of the samples with low energy density; the friction of the samples with two energy densities in aqueous solution is faster than dry friction in air and tends to be stable. The friction coefficient in 3.5% NaCl solution is the smallest; when the energy density is constant, the wear depth of the fretting wear is the largest under dry friction and the smallest in distilled water. Under dry-friction conditions, the wear mechanisms of fretting wear are mainly oxidative wear and adhesive wear. In the fretting wear in the distilled water and the 3.5% NaCl solution, both wear mechanisms are abrasive wear and fatigue wear.
Keywords
Funding Information
- National Natural Science Foundation of China (51905032, 51975042)
- Science and Technology Innovation Special Fund, Foshan (BK20BE024, BK21BE018)
This publication has 22 references indexed in Scilit:
- Experimental study on wear behaviors of TBM disc cutter ring under drying, water and seawater conditionsWear, 2017
- 316L stainless steel mechanical and tribological behavior—A comparison between selective laser melting, hot pressing and conventional castingAdditive Manufacturing, 2017
- Influence of ionic species on scaling and corrosion performance of AISI 316L rotating disk electrodes in artificial seawaterDesalination, 2017
- A review on selective laser sintering/melting (SLS/SLM) of aluminium alloy powders: Processing, microstructure, and propertiesProgress in Materials Science, 2015
- Investigation into the effect of process parameters on microstructural and physical properties of 316L stainless steel parts by selective laser meltingThe International Journal of Advanced Manufacturing Technology, 2014
- Sliding Wear Characteristics and Corrosion Behaviour of Selective Laser Melted 316L Stainless SteelJournal of Materials Engineering and Performance, 2013
- Tribocorrosion Behaviors of Inconel 625 Alloy Sliding against 316 Steel in SeawaterTribology Transactions, 2011
- Friction and Wear Performance of An Aluminium Alloy in Artificial SeawaterProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2011
- Direct laser sintering of metal powders: Mechanism, kinetics and microstructural featuresMaterials Science and Engineering: A, 2006
- Different aspects of the role of wear debris in fretting wearWear, 2002