Fatigue Behavior of Hi‐Nicalon Type‐S ™ /BN/SiC Ceramic Matrix Composites in a Combustion Environment
Authors:
- 3 September 2010
- journal article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 8 (2) , 261-272
Abstract
The fatigue behavior of Hi‐Nicalon Type‐S ™ /BN/SiC ceramic matrix composites (CMCs) was investigated in a combustion environment. Two versions of this CMC were tested. The first version was manufactured by a slurry casting process using woven fiber architecture and the matrix was densified by melt‐infiltration (MI) of silicon. The other was a cross‐ply laminate prepared by a traditional lamination process from unidirectional prepreg followed by the MI processing. Several tests were conducted at a frequency of 1 Hz and a stress ratio of 0.05 to develop the fatigue life diagrams for both material systems. The Prepreg MI CMC exhibited higher fatigue strength, especially for cycles‐to‐failure >10,000, in comparison with the slurry cast MI CMC. Micrographic analysis was conducted to document the oxidation and embrittlement, which was observed to be dependent upon the applied stress level and cycles‐to‐failure. Overall, the prepreg MI CMC was less prone to oxidation and had better fatigue properties, demonstrating the potential for long‐term use as a structural high‐temperature material for high‐temperature oxidative service environments, such as those found in gas turbine engines.Keywords
This publication has 13 references indexed in Scilit:
- Design Guidelines for In‐Plane Mechanical Properties of SiC Fiber‐Reinforced Melt‐Infiltrated SiC CompositesInternational Journal of Applied Ceramic Technology, 2009
- Silicon Melt Infiltrated Ceramic Composites (HiPerComp™)2006
- Non-oxide (Silicon Carbide) Fibers2006
- SiC/SiC Composites for 1200°C and Above2005
- Interfacial characterization of a slurry-cast melt-infiltrated SiC/SiC ceramic-matrix compositeActa Materialia, 2000
- Intermediate‐Temperature Stress Rupture of a Woven Hi‐Nicalon, BN‐Interphase, SiC‐Matrix Composite in AirJournal of the American Ceramic Society, 2000
- HSR/EPM combustor materials development programMaterials Science and Engineering: A, 1999
- Fatigue of ceramic matrix compositesActa Metallurgica et Materialia, 1995
- Failure Mechanisms in Ceramic‐Fiber/Ceramic‐Matrix CompositesJournal of the American Ceramic Society, 1985
- Chemical kinetic reaction mechanism for the combustion of propaneCombustion and Flame, 1984