A round-robin finite element analysis of human femur mechanics between seven participating laboratories with experimental validation
- 13 May 2019
- journal article
- research article
- Published by Taylor & Francis in Computer Methods in Biomechanics and Biomedical Engineering
- Vol. 22 (12) , 1020-1031
Abstract
Finite element analysis is a common tool that has been used for the past few decades to predict the mechanical behavior of bone. However, to our knowledge, there are no round-robin finite element analyses of long human bones with more than two participating biomechanics laboratories published yet, where the results of the experimental tests were not known in advance. We prepared a fresh-frozen human femur for a compression test in a universal testing machine measuring the strains at 10 bone locations as well as the deformation of the bone in terms of the displacement of the loading point at a load of 2 kN. The computed tomography data of the bone with a calibration phantom as well as the orientation of the bone in the testing machine with the according boundary conditions were delivered to seven participating laboratories. These were asked to perform a finite element analysis simulating the experimental setup and deliver their results to the coordinator without knowing the experimental results. Resultantly, four laboratories had deviations from the experimentally measured strains of less than 40%, and three laboratories had deviations of their numerically determined values compared to the experimental data of more than 120%. These deviations are thought to be based on different material laws and material data, as well as different material mapping methods. Investigations will be conducted to clarify and assess the reasons for the large deviations in the numerical data. It was shown that the precision of finite element models of the human femur is not yet as developed as desired by the biomechanics community.Keywords
This publication has 32 references indexed in Scilit:
- Parametric study of patient-specific femoral locking plates based on a combined musculoskeletal multibody dynamics and finite element modelingProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 2017
- Comparisons of node-based and element-based approaches of assigning bone material properties onto subject-specific finite element modelsMedical Engineering & Physics, 2015
- Comparison of eight published static finite element models of the intact lumbar spine: Predictive power of models improves when combined togetherJournal of Biomechanics, 2014
- Individual density–elasticity relationships improve accuracy of subject-specific finite element models of human femursJournal of Biomechanics, 2013
- A nonlinear QCT-based finite element model validation study for the human femur tested in two configurations in vitroBone, 2013
- An investigation to determine if a single validated density–elasticity relationship can be used for subject specific finite element analyses of human long bonesMedical Engineering & Physics, 2012
- Grand challenge competition to predict in vivo knee loadsJournal of Orthopaedic Research, 2011
- Finite element prediction of proximal femur fracture pattern based on orthotropic behaviour law coupled to quasi-brittle damageMedical Engineering & Physics, 2011
- In situ parameter identification of optimal density–elastic modulus relationships in subject-specific finite element models of the proximal femurMedical Engineering & Physics, 2010
- Numerical investigations on the strain-adaptive bone remodelling in the periprosthetic femur: Influence of the boundary conditionsBioMedical Engineering OnLine, 2009