Effect of As-Built and Ground Surfaces on the Fatigue Properties of AlSi10Mg Alloy Produced by Additive Manufacturing
Open Access
Abstract
The present work concerns the influence of surface (machined, as-built) on the fatigue resistance of AlSi10Mg produced by a powder-bed laser process. The competition between defects and surface roughness is assessed by using Kitagawa-type diagrams. Samples are printed along three directions: 0°, 45° and 90°. After axial fatigue tests with a load ratio of R = −1, all the fracture surfaces are carefully analysed. The initiation sites can be (i) a defect, (ii) the surface roughness, (iii) the surface ripple. The results indicate that ground surfaces lead to the same fatigue life as as-built surfaces. It is also shown that T6 treatment improves the fatigue resistance. However, when specimen surfaces are as-built or ground, it is difficult to correlate the fatigue results with ‘isolated defect size analysis’ neither roughness parameter for an as-built surface. Therefore, microstructure, residual stresses or multiple initiation should be further analysed to understand the results.Keywords
This publication has 29 references indexed in Scilit:
- Influence of casting defect and SDAS on the multiaxial fatigue behaviour of A356-T6 alloy including mean stress effectInternational Journal of Fatigue, 2015
- A review on selective laser sintering/melting (SLS/SLM) of aluminium alloy powders: Processing, microstructure, and propertiesProgress in Materials Science, 2015
- Evaluation of Orientation Dependence of Fracture Toughness and Fatigue Crack Propagation Behavior of As-Deposited ARCAM EBM Ti-6Al-4VJOM, 2015
- Topologically Optimized Diesel Engine Support Manufactured with Additive ManufacturingIFAC-PapersOnLine, 2015
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013
- Additive manufactured AlSi10Mg samples using Selective Laser Melting (SLM): Microstructure, high cycle fatigue, and fracture behaviorMaterials & Design (1980-2015), 2012
- Mechanical Properties of AlSi10Mg Produced by Selective Laser MeltingPhysics Procedia, 2012
- Multiaxial Kitagawa analysis of A356-T6International Journal of Fatigue, 2011
- Influence of casting defects on the fatigue limit of nodular cast ironInternational Journal of Fatigue, 2004
- Effects of defects, inclusions and inhomogeneities on fatigue strengthInternational Journal of Fatigue, 1994