Fabrication and properties of poly(l‐lactide) nanofibers via blend sea‐island melt spinning
Authors:
- 23 July 2014
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 132 (1)
Abstract
Poly(l‐lactide) (PLLA) nanofibers were prepared by melt extrusion of immiscible blends of PLLA/low density polyethylene (LDPE) and subsequent removal of the LDPE matrix from the blend fibers. The effect of blends composition and draw ratio on the phase structure of the blend fibers, crystallization, mechanical properties, and the diameter of the PLLA nanofibers was investigated. It is found that the diameter of the PLLA phase gradually increases with the increase of PLLA content. With the variation of PLLA content from 50 to 60 wt %, the average diameter of acquired PLLA nanofibers changes from 119 to 153 nm under the draw ratio of 1.5. When further increasing the content of PLLA to 65%, it is difficult to acquire PLLA nanofibers due to the poor dissolving properties between PLLA and LDPE components. Oriented PLLA nanofibers with the average diameter of 92 nm can be fabricated from PLLA/LDPE (50/50, wt %) blends under the draw ratio of 2. The present results suggest that it is possible to acquire polymer nanofibers with high output using blend sea‐island melt spinning. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 41228.Keywords
This publication has 29 references indexed in Scilit:
- Preparation of polyester nanofibers and nanofiber yarns from polyester/cellulose acetate butyrate immiscible polymer blendsJournal of Applied Polymer Science, 2011
- Morphology evolution of polypropylene in immiscible polymer blends for fabrication of nanofibersJournal of Polymer Science Part B: Polymer Physics, 2010
- Polypyrrole-coated electrospun PLGA nanofibers for neural tissue applicationsBiomaterials, 2009
- Micro and nano fibrils from polypropylene/nylon 6 blendsJournal of Applied Polymer Science, 2008
- Controllable fabrication and properties of polypropylene nanofibersPolymer Engineering & Science, 2007
- Melt-electrospinning part I: processing parameters and geometric propertiesPolymer, 2004
- Crystal transformation from the α- to the β-form upon tensile drawing of poly(l-lactic acid)Polymer, 2004
- Preparation of oriented β‐form poly(L‐lactic acid) by solid‐state extrusionJournal of Polymer Science Part B: Polymer Physics, 2001
- Factors influencing structure formation and phase size in an immiscible polymer blend of polycarbonate and polypropylene prepared by twin-screw extrusionPolymer, 1991
- Phase size/composition dependence in immiscible blends: Experimental and theoretical considerationsJournal of Polymer Science Part B: Polymer Physics, 1990