The impact of laser surface treatment on the microstructure, wear resistance and hardness of the AlMg5 aluminum alloy
Open Access
- 26 February 2020
- journal article
- research article
- Published by Springer Nature in Applied Physics A
- Vol. 126 (3) , 1-10
Abstract
Light metal alloys due to several unique properties such as low density and high corrosion resistance are increasingly used in various technical applications, where the automotive industry is one of the most important sectors. The automotive applications use mostly aluminum alloys, where the strength to density ratio of the material plays a crucial factor. Unfortunately, relatively low mechanical properties limit their applications for parts where a high surface hardness and wear resistance is expected. The classic heat treatment of aluminum alloys can only in some limited ranges improve the bulk material properties. Despite this, surface treatment with laser processing has developed significantly over the past 20 years. The laser beam treatment allows the introduction of a wide range of alloying elements to the surface layer of an aluminum alloy and thus, as a result of the precipitation of numerous intermetallic phases, significantly increases hardness, and abrasion resistance. The purpose of this work was to modify the aluminum surface layer using high-power fiber laser (HPFL). During this process, a mixture of titanium and iron powders (90/10 wt.%) was introduced onto the surface of the AlMg5 alloy. The microhardness tests carried out by the Vickers method and tribological tests showed a significant increase in mechanical properties in the entire volume of the obtained layer. Research on light and scanning microscopy revealed fragmentation of primary precipitates and the formation of numerous intermetallic phases rich in titanium and aluminum.Keywords
This publication has 27 references indexed in Scilit:
- On achieving superior strength for Al–Mg–Zn alloy adopting cold ECAPVacuum, 2020
- Aluminium Matrix Composites Produced by Laser Based Additive ManufacturingMaterials Today: Proceedings, 2019
- Wrought aluminium–magnesium alloys subjected to SPD processingInternational Journal of Materials Research, 2016
- Electron Microscope Investigation of PVD Coated Aluminium Alloy Surface LayerSolid State Phenomena, 2012
- Wear and corrosion behaviour of HVOF WC–CoCr/CVD DLC hybrid coating systems deposited onto aluminium substrateSurface and Coatings Technology, 2011
- Structural, mechanical and tribological properties of A356 aluminium alloy reinforced with Al2O3, SiC and SiC+graphite particlesJournal of Alloys and Compounds, 2010
- HVOF thermal sprayed coatings on aluminium alloys and aluminium matrix compositesSurface and Coatings Technology, 2005
- Influence of heat treatment on the microstructure and mechanical properties of 6005 and 6082 aluminium alloysJournal of Materials Processing Technology, 2005
- Recent development in aluminium alloys for the automotive industryMaterials Science and Engineering: A, 2000
- Plastic deformation of alloys with submicron-grained structureMaterials Science and Engineering: A, 1991