Energy Supply and ULP Detection Circuits for an RFID Localization System in 130 nm CMOS
- 24 June 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 45 (7) , 1273-1285
Abstract
This paper presents both an integrated energy supply and detection circuits for an RFID localization system. The equations to calculate the expected AC antenna voltage are presented as well as a fast method to calculate the expected output voltage from a rectifier. An ultra low power voltage detection circuit is described which monitors the output voltage of the rectifier and consumes only 3 nW. Also the input of the rectifier is monitored by an input power dip detection circuit, which provides a pulse whenever the amplitude of the AC antenna signal drops to zero. This circuit too, is ultra low power and consumes only 5 nW from a 0.5 V supply. It can even serve as an OOK demodulator for bitrates up to 6.7 kbps. All circuits have been designed in a 130 nm CMOS process. Measurement results are presented for all circuits.Keywords
This publication has 13 references indexed in Scilit:
- Ultra low power detection circuits in 130nm CMOS for a wireless UWB localization system2009
- RFID, where are they?2009
- A 3-tier UWB-based indoor localization system for ultra-low-power sensor networksIEEE Transactions on Wireless Communications, 2009
- A RF to DC Voltage Conversion Model for Multi-Stage Rectifiers in UHF RFID TranspondersIEEE Journal of Solid-State Circuits, 2009
- A Fully Integrated Pinless Long-Range Power Supply with On-Chip Antenna for Scavenging-Based RFID Tag Powering2009
- Power processing circuits for vibration-based energy harvesters2008
- A low-power mixing DAC IR-UWB-receiver2008
- A fully integrated wireless power supply for pinless active RFID-devices in 130nm CMOS2007
- A model for /spl mu/-power rectifier analysis and designIEEE Transactions on Circuits and Systems I: Regular Papers, 2005
- On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier techniqueIEEE Journal of Solid-State Circuits, 1976