The Theoretical Analysis and Design of Coding BOTDR System With APD Detector
Authors:
- 6 March 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 14 (8) , 2626-2632
Abstract
The signal-to-noise ratio and the coding gain of Brillouin optical time domain reflectometry system with APD detector are analyzed. In coding distributed optical fiber sensing system, there are a large number of multipath interferences (MPIs), which are proportional to the code length. The random shot noise caused by MPI will be generated before decoding and cannot be eliminated by decoding process. In addition, the shot noise power is proportional to the square of the code length; the thermal noise power increases linearly with the code length, then, the increase of the speed of the coding gain will be decreased with the increase of the code length. When the shot noise is much larger than the thermal noise, the coding gain will not be increased with the increase of the code length, but will maintain a constant value. This conclusion is in contradiction with the traditional conclusion. At the same time, the shot noise depends on the pulsewidth and power, but the thermal noise is independent on the pulsewidth and the power, so there exists an optimum code length for specific system.Keywords
Funding Information
- National Natural Science Foundation of China (61067005)
- Key Project of Chinese Ministry of Education (210119)
- Aviation Science Foundation (2010ZA56001)
- Key Laboratory of Nondestructive Testing, Ministry of Education, Nanchang Hangkong University (ZD200929008)
This publication has 9 references indexed in Scilit:
- The use of Walsh code in modulating the pump light of high spatial resolution phase-shift-pulse Brillouin optical time domain analysis with non-return-to-zero pulsesMeasurement Science and Technology, 2013
- 1-cm-Spatial-Resolution Brillouin Optical Time-Domain Analysis Based on Bright Pulse Brillouin Gain and Complementary CodeIEEE Photonics Journal, 2012
- Simplex-coded BOTDA fiber sensor with 1 m spatial resolution over a 50 km rangeOptics Letters, 2010
- Optimization of SNR improvement in the noncoherent OTDR based on simplex codesJournal of Lightwave Technology, 2006
- SNR enhancement of OTDR using biorthogonal codes and generalized inversesIEEE Photonics Technology Letters, 2004
- Temperature and strain dependence of the power level and frequency of spontaneous Brillouin scattering in optical fibersOptics Letters, 1997
- Using simplex codes to improve OTDR sensitivityIEEE Photonics Technology Letters, 1993
- BOTDA-nondestructive measurement of single-mode optical fiber attenuation characteristics using Brillouin interaction: theoryJournal of Lightwave Technology, 1989
- Real-time long range complementary correlation optical time domain reflectometerJournal of Lightwave Technology, 1989