Possible manufacturing tolerance faults in design and construction of low speed slotless permanent magnet generator
Authors:
- 1 August 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-10
Abstract
This paper describes manufacturing tolerance faults that may occur during the design of electrical machines. Examples of the manufacturing tolerances are based on the design and construction process of a slotless permanent magnet wind generator. Experiments are carried out on the reference machine.Keywords
This publication has 15 references indexed in Scilit:
- Analysis of a slow-speed slotless permanent magnet synchronous generator2013
- Analysis of converter topological structure for direct-drive wind power system with PMSG2010
- Computation of additional losses due to rotor eccentricity in electrical machinesIET Electric Power Applications, 2010
- Phenomenon of magnetic force in permanent magnet wind turbine generators2009
- Unbalanced Magnet Pull in Large Brushless Rare-Earth Permanent Magnet Motors With Rotor EccentricityIEEE Transactions on Magnetics, 2009
- Static-, Dynamic-, and Mixed-Eccentricity Fault Diagnoses in Permanent-Magnet Synchronous MotorsIEEE Transactions on Industrial Electronics, 2009
- 10 MW Wind Turbine Direct-Drive Generator Design with Pitch or Active Speed Stall Control2007
- Detecting Rotor Faults in Low Power Permanent Magnet Synchronous MachinesIEEE Transactions on Power Electronics, 2007
- A method for detection of eccentricity in permanent magnet machines2004
- Comparison of dynamic responses for IPM and SPM motors by considering mechanical and magnetic couplingIEEE Transactions on Magnetics, 2001