Fabrication of Nanostructured NiO Thick Films by Facile Printing Method and their Dye-Sensitized Solar Cell Performance
Authors:
- 1 July 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 445, 74-77
Abstract
Nanostructured NiO thick films were fabricated for use in dye-sensitized solar cells (DSCs) as photocathodes. Pastes were prepared by using nanocrystalline NiO powders, polyethylene glycol (PEG) and water. The pastes were then printed on FTO glass substrates by a facile doctor-blade printing method. The NiO films were obtained by heating at 500 °C for 30 min in flowing oxygen. It was shown that the nanostructure of the resultant films was largely dependent on the amount of PEG in the pastes. Coumarin 343 (C343) dye was employed for sensitizing p-type NiO photocathodes. DSCs using our NiO/C343 photocathodes yielded a photocurrent density of 1.26 mA cm–2, an open-circuit photovoltage of 88 mV, a fill factor of 0.33, and a solar energy conversion efficiency of 0.037 %.Keywords
This publication has 4 references indexed in Scilit:
- Fabrication and photovoltaic properties of dye-sensitized ZnO thick films by a facile doctor-blade printing method using nanocrystalline pastesJournal of the Ceramic Society of Japan, 2009
- Large photocurrent generation in dye-sensitized ZnO solar cellsEnergy & Environmental Science, 2008
- Fabrication and Dye-Sensitized Solar Cell Performance of Nanostructured NiO/Coumarin 343 PhotocathodesElectrochemical and Solid-State Letters, 2008
- A High Voltage Dye-sensitized Solar Cell using a Nanoporous NiO PhotocathodeChemistry Letters, 2005