Microstructure and tensile properties of injection molded thermoplastic polyurethane with different melt temperatures
- 2 January 2020
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 137 (29)
Abstract
The use of injection molding technology to prepare heterogeneous interlayer film of laminated glass holds strong applicable potential. This article aims to investigate the effects of melt temperature and melt flow on the microstructure evolution and tensile properties of thermoplastic polyurethane (TPU) specimens during the injection molding process. The tensile properties of the TPU specimens show dependency on the melt temperature and melt flow direction. The results of birefringence indicate that melt flow and lower melt temperature induce higher stretching deformation of the molecular chain network. Small‐angle X‐ray scattering analysis approves that besides the melt temperature and flow direction, the testing position on the cross section of the specimen has great influence on the microstructure of the TPU sheet. Further analysis and conclusions can be made using wide‐angle X‐ray scattering method. The above results demonstrate that both the tensile properties and microstructure of the injection molded TPU specimens tend to be isotropic with the increase of melt temperature. © 2020 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020, 137, 48891.Keywords
This publication has 35 references indexed in Scilit:
- Thermoplastic polyurethanes derived from petrochemical or renewable resources: A comprehensive reviewPolymer Engineering & Science, 2017
- Optical properties of orthodontic aligners—spectrophotometry analysis of three types before and after agingProgress in Orthodontics, 2015
- Synthesis and characterization of an ultra-soft poly(carbonate urethane)European Polymer Journal, 2015
- Maximizing the utility of bio-based diisocyanate and chain extenders in crystalline segmented thermoplastic polyester urethanes: Effect of polymerization protocolPolymer, 2014
- Synthesis, structure and properties of fully biobased thermoplastic polyurethanes, obtained from a diisocyanate based on modified dimer fatty acids, and different renewable diolsEuropean Polymer Journal, 2014
- The influences of deformation state and experimental conditions on inelastic behaviour of an extruded thermoplastic polyurethane elastomerMaterials & Design (1980-2015), 2013
- Study on the Influence of Melt Processing on Segmented Polyurethanes MorphologyMacromolecular Symposia, 2010
- Influence of the prepolymerization on the properties of thermoplastic polyurethane elastomers. Part I. Prepolymer characterizationJournal of Applied Polymer Science, 2000
- Influence of processing conditions on the multiphase structure of segmented polyurethanePolymer, 1998
- A synchrotron SAXS study of the structure development kinetics during the reactive processing of flexible polyurethane foamNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1995