Comparison of Mechanical and Corrosion Properties Between Coarse-Grained and Ultrafine-Grained High-Strength Aluminum Alloys
Open Access
Abstract
Multi-axial forging (MAF) and aging were employed to process a high-strength aluminum alloy. The tensile properties, microstructure, and corrosion behavior were researched. After MAF, the strength of the alloy was observably increased, but the elongation was decreased. The strengthening mechanism resulted from dislocation multiplication and grain size reduction. After aging, strength was enhanced further, and elongation was improved. The strength and elongation are 561 MPa and 12.3%. Moreover, the corrosion resistance was obviously enhanced. The further strengthening is mainly attributed to the precipitation strengthening. The larger size and discontinuous distribution of grain boundary precipitates resulted in the alloy having higher corrosion resistance.Keywords
Funding Information
- Key Research and Development Plan Project of Guangxi, China (Guike AB22080015)
This publication has 32 references indexed in Scilit:
- Corrosion behavior of nano-treated AA7075 alloy with TiC and TiB2 nanoparticlesCorrosion Science, 2022
- Microstructures and properties evolution of spray-deposited Al-Zn-Mg-Cu-Zr alloys with scandium additionJournal of Alloys and Compounds, 2017
- Effect of Aging Treatments on the Mechanical and Corrosive Behaviors of Spray-Formed 7075 AlloyJournal of Materials Engineering and Performance, 2014
- Precipitation kinetics in a severely plastically deformed 7075 aluminium alloyActa Materialia, 2014
- Microstructure and mechanical properties of ultra-fine grains (UFGs) aluminum strips produced by ARB processJournal of Alloys and Compounds, 2009
- Influence of temper and surface condition on the exfoliation behaviour of high strength Al–Zn–Mg–Cu alloysCorrosion Science, 2007
- Simultaneously Increasing the Ductility and Strength of Nanostructured AlloysAdvanced Materials, 2006
- Achieving High Strength and High Ductility in Precipitation‐Hardened AlloysAdvanced Materials, 2005
- Toughness-strength relations in the overaged 7449 al-based alloyMetallurgical and Materials Transactions A, 2002
- The effect of copper content and heat treatment on the stress corrosion characteristics of Ai-6Zn-2Mg-X Cu alloysMetallurgical Transactions A, 1981