Identification of dynamic coefficient matrix for drilling process simulations from measured tool geometry, axial force and torque
- 12 June 2024
- journal article
- research article
- Published by Elsevier in CIRP Journal of Manufacturing Science and Technology
- Vol. 52, 159-174
Abstract
No abstract availableKeywords
This publication has 25 references indexed in Scilit:
- Generalized mechanics and dynamics of metal cutting operations for unified simulationsInternational Journal of Machine Tools and Manufacture, 2016
- Modeling the mechanics and dynamics of arbitrary edge drillsInternational Journal of Machine Tools and Manufacture, 2015
- Unified cutting force model for turning, boring, drilling and milling operationsInternational Journal of Machine Tools and Manufacture, 2012
- Continuous chip formation in drillingInternational Journal of Machine Tools and Manufacture, 2005
- Forces and hole quality in drillingInternational Journal of Machine Tools and Manufacture, 2005
- Extracting cutting force coefficients from drilling experimentsInternational Journal of Machine Tools and Manufacture, 2005
- Calculation of main cutting edge forces and torque for drills with arbitrary point geometriesInternational Journal of Machine Tools and Manufacture, 1992
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. II — revised cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- Effect of point geometry and dimensional symmetry on drill performanceInternational Journal of Machine Tool Design and Research, 1961