Further Improvement in Mechanical Properties of Highly Anisotropic Silicon Nitride Ceramics
Authors:
- 1 March 2000
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 83 (3) , 495-500
Abstract
Si 3 N 4 ceramics were fabricated by tape casting of a raw‐powder slurry seeded with three types of rodlike β‐Si 3 N 4 particles. The effects of seed size on the microstructure and mechanical properties of the sintered specimens were investigated. All the seeded and tape‐cast silicon nitrides presented an anisotropic microstructure, where the elongated grains grown from seeds were preferentially oriented parallel to the casting direction. The orientation degree of these grains, f 0 , was affected by seed size, and small‐seed addition led to the highest f 0 value. This material exhibited high bending strength (∼1.4 GPa) and high fracture toughness (∼12 MPa . m 1/2 ) in the direction normal to the grain alignment, which were attributed to the highly anisotropic and fine microstructure.Keywords
This publication has 16 references indexed in Scilit:
- Mechanical Properties of Silicon Nitrides with Tailored Microstructure by SeedingJournal of the Ceramic Society of Japan, 1996
- Fracture Resistance Behavior of Highly Anisotropic Silicon NitrideJournal of the American Ceramic Society, 1995
- Microstructure Control of Silicon Nitride by Seeding with Rodlike β‐Silicon Nitride ParticlesJournal of the American Ceramic Society, 1994
- Effect of Grain Growth of β‐Silicon Nitride on Strength, Weibull Modulus, and Fracture ToughnessJournal of the American Ceramic Society, 1993
- Self-Reinforced Silicon Nitride by Gas Pressure Sintering1993
- Microstructural Development During Gas‐Pressure Sintering of α‐Silicon NitrideJournal of the American Ceramic Society, 1992
- Grain Size Dependence of the Fracture Toughness of Silicon Nitride CeramicsJournal of the Ceramic Society of Japan, 1991
- Super-Tough Silicon Nitride with R-Curve Behavior1989
- Evaluation of Fracture Toughness for Ceramic Materials by a Single‐Edge‐Precracked‐Beam MethodJournal of the American Ceramic Society, 1988
- Behavior of discontinuous fiber composites: Fiber orientationPolymer Composites, 1982