Vacuum sealed and getter activated MEMS Quad Mass Gyroscope demonstrating better than 1.2 million quality factor
- 1 February 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 142-143
Abstract
This paper presents the in-run bias stability of a high Q-factor Quad Mass Gyroscope (QMG), vacuum sealed with getter activated in Leadless Chip Carrier (LCC) package. Quality factors of 1.2 and 1.1 Million were measured along the layout-defined drive and sense modes. As-fabricated, frequency mismatch of 35Hz was electrostatically tuned to 200mHz, for a device with 2kHz center frequency. A performance improvement of 4X in Angle Random Walk (ARW) and 15X reduction in in-run bias stability were achieved after the electrostatic frequency matching between drive and sense modes, resulting in below 0.1 deg/hr bias stability. The results showed a strong dependency of the in-run bias stability of the gyroscope due to quality factor and frequency mismatches.Keywords
This publication has 4 references indexed in Scilit:
- Mode ordering in tuning fork structures with negative structural coupling for mitigation of common-mode g-sensitivity2015
- Flat is not dead: Current and future performance of Si-MEMS Quad Mass Gyro (QMG) system2014
- Sub-degree-per-hour silicon MEMS rate sensor with 1 million Q-factor2011
- Ultra-high Q silicon gyroscopes with interchangeable rate and whole angle modes of operation2010