Fabrication of Polysulfone/ZnO Membrane: Influence of ZnO Nanoparticles on Membrane Characteristics
Authors:
- 30 August 2013
- journal article
- Published by Wiley in Advances in Polymer Technology
- Vol. 32 (4)
Abstract
A mixed matrix membrane consisting of a polysulfone and nano‐ZnO particles has been fabricated by a combination of solution dispersion blending and phase‐inversion method. The study is focused on the influence of ZnO on membrane morphology, surface roughness, and hydrophilicity, which were investigated through the methods of scanning electron microscopy, atomic force microscopy, and contact angle meter, respectively. In addition, the changes in membrane characteristics with the addition nano‐ZnO particles were examined by pure water flux, water content and porosity, and salts rejection including NaCl and MgSO4. From the results, it was revealed that nano‐ZnO particles constructed a membrane having more hydrophilic, smooth, and tightly packed surface, which offered a high flux and an effective permeability barrier. Moreover, it was observed that nano‐ZnO particles produced spongy a membrane with uniform and well‐interconnecting pores. © 2013 Wiley Periodicals, Inc. Adv Polym Technol 2013, 32, 21369; View this article online at wileyonlinelibrary.com. DOI 10.1002/adv.21369Keywords
This publication has 37 references indexed in Scilit:
- Polysulfone membranes blended with ZnO nanoparticles for reducing fouling by oleic acidSeparation and Purification Technology, 2012
- Pure sponge-like membranes bearing both high water permeability and high retention capacityDesalination, 2011
- Structural, optical, photo catalytic and antibacterial activity of ZnO and Co doped ZnO nanoparticlesMaterials Letters, 2011
- Comparative assessment of hydrophobic and hydrophilic membrane fouling in wastewater applicationsJournal of Membrane Science, 2009
- Preparation, characterization and performance of Al2O3/PES membrane for wastewater filtrationJournal of Membrane Science, 2009
- Rheological and thermodynamic variation in polysulfone solution by PEG introduction and its effect on kinetics of membrane formation via phase-inversion processJournal of Membrane Science, 2006
- Preparation of TiO self-assembled polymeric nanocomposite membranes and examination of their fouling mitigation effects in a membrane bioreactor systemJournal of Membrane Science, 2005
- Influence of inorganic fillers on the compaction behaviour of porous polymer based membranesJournal of Membrane Science, 2004
- Design of TiO2 nanoparticle self-assembled aromatic polyamide thin-film-composite (TFC) membrane as an approach to solve biofouling problemJournal of Membrane Science, 2003
- Changes in morphology and transport characteristics of polysulfone membranes prepared by different demixing conditionsJournal of Membrane Science, 1995