Tests of X- and K-Joints in SHS Stainless Steel Tubes
- 1 October 2001
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 127 (10) , 1173-1182
Abstract
This paper describes a test program on welded stainless steel X- and K-joints fabricated from square hollow section (SHS) brace members and chords. The X-joints were tested in compression and tension using different ratios of brace width to chord width. The K-joints were tested by varying the ratio of brace width to chord width, the angle between chord and brace members, and the preload applied to the chord. A total of 23 tests were performed. Design rules are proposed for X- and K-joints by adopting the rules of the Comité International pour le Developpement et l'Etude de la Construction Tubulaire (CIDECT) recommendations for carbon steel tubular structures and replacing the yield stress in these recommendations by a proof stress. It is shown that the 0.2% proof stress, as determined from the finished tube, can be used to determine the ultimate strength using the CIDECT design rules and that the serviceability limit state corresponding to joint deformations of 1% of the chord width will not be reached if...Keywords
This publication has 5 references indexed in Scilit:
- Tests of X- and K-Joints in CHS Stainless Steel TubesJournal of Structural Engineering, 2001
- Deformation limit and ultimate strength of welded T-joints in cold-formed RHS sectionsJournal of Constructional Steel Research, 2000
- Design of Cold‐Formed Stainless Steel Tubular Members. II: BeamsJournal of Structural Engineering, 1993
- Design of Cold‐Formed Stainless Steel Tubular Members. I: ColumnsJournal of Structural Engineering, 1993
- Local buckling of braces in tubular K-jointsThin-Walled Structures, 1986