Harnessing Environmental Sensitivity in SnSe-Based Metal–Semiconductor–Metal Devices: Unveiling Negative Photoconductivity for Enhanced Photodetector Performance and Humidity Sensing
Authors:
- 14 May 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (20) , 26899-26914
Abstract
The extreme sensitivity of 2D-layered materials to environmental adsorbates, which is typically seen as a challenge, is harnessed in this study to fine-tune the material properties. This work investigates the impact of environmental adsorbates on electrical properties by studying metal-semiconductor-metal (MSM) devices fabricated on CVD-synthesized SnSe flakes. The freshly prepared devices exhibit positive photoconductivity (PPC), whereas they gradually develop negative photoconductivity (NPC) after being exposed to an ambient environment for ∼1 day. While the photodetectors based on positive photoconductivity exhibit a responsivity and detectivity of 6.1 A/W and 5.06 × 108 Jones, the same for the negative photoconductivity-based photodetector reaches up to 36.3 A/W and 1.49 × 109 Jones, respectively. In addition, the noise-equivalent power of the NPC photodetector decreases by 300 times as compared to the PPC device, which implies a prominent detection capability of the NPC device against weak photo signals. To substantiate the hypothesis that negative photoconductivity stems from the photodesorption of water and oxygen molecules on the dangling bonds of SnSe flakes, the flakes are etched along the most active planes (010) with a focused laser beam in an inert environment, which enhances responsivity by 43%, supporting negative photoconductivity linked to photodesorption. Furthermore, the humidity-dependent dark current variation of the NPC photodetectors is used to design a humidity sensor for human respiration monitoring with faster response and recovery times of 0.72 and 0.68 s, respectively. These findings open up the possibility of tuning the photoelectrical response of layered materials in a facile manner to develop future sensors and optoelectronic multifunctional devices.Keywords
Funding Information
- Council of Scientific and Industrial Research, India (09/1129(12879)/2021-EMR-I)
- Ministry of Textiles, Government of India (2/3/2021-NTTM)
- University Grants Commission
This publication has 65 references indexed in Scilit:
- Recent Advances in SnSe Nanostructures beyond ThermoelectricityAdvanced Functional Materials, 2022
- SnSe field-effect transistors with improved electrical propertiesNano Research, 2021
- Functional Group‐induced p‐Doping of MoS2 by Titanium(IV) Bis(ammonium lactato) Dihydroxide PhysisorptionChemistry – An Asian Journal, 2021
- Recent Advances in 2D Metal MonochalcogenidesAdvanced Science, 2020
- Improved Response/Recovery Time and Sensitivity of SnSe Nanosheet Humidity Sensor by LiCl IncorporationAdvanced Electronic Materials, 2020
- Facile Synthesis of γ‐In2Se3 Nanoflowers toward High Performance Self‐Powered Broadband γ‐In2Se3/Si Heterojunction PhotodiodeSmall, 2017
- Epitaxy of Ultrathin SnSe Single Crystals on Polydimethylsiloxane: In‐Plane Electrical Anisotropy and Gate‐Tunable ThermopowerAdvanced Electronic Materials, 2016
- Transition‐Metal Substitution Doping in Synthetic Atomically Thin SemiconductorsAdvanced Materials, 2016
- Booming Development of Group IV–VI Semiconductors: Fresh Blood of 2D FamilyAdvanced Science, 2016
- Efficiency of ab-initio total energy calculations for metals and semiconductors using a plane-wave basis setComputational Materials Science, 1996