Prediction of the Bending Strength of a Composite Steel Beam–Slab Member Filled with Recycled Concrete
Authors:
- Mohammed Chyad LiejyMohammed Chyad Liejy
- Ahmed W. Al ZandAhmed W. Al Zand
- Azrul A. MutalibAMAzrul A. Mutalib
- Ali A. AbdulhameedAli A. Abdulhameed
- A. B. M. A. KaishA. B. M. A. Kaish
- Wadhah M. TawfeeqWTWadhah M. Tawfeeq
- Shahrizan BaharomSBShahrizan Baharom
- Alyaa A. Al-AttarAlyaa A. Al-Attar
- Ammar N. HanoonAHAmmar N. Hanoon
- Zaher Mundher YaseenZaher Mundher Yaseen
Open Access
Abstract
This study investigated the structural behavior of a beam–slab member fabricated using a steel C-Purlins beam carrying a profile steel sheet slab covered by a dry board sheet filled with recycled aggregate concrete, called a CBPDS member. This concept was developed to reduce the cost and self-weight of the composite beam–slab system; it replaces the hot-rolled steel I-beam with a steel C-Purlins section, which is easier to fabricate and weighs less. For this purpose, six full-scale CBPDS specimens were tested under four-point static bending. This study investigated the effect of using double C-Purlins beams face-to-face as connected or separated sections and the effect of using concrete material that contains different recycled aggregates to replace raw aggregates. Test results confirmed that using double C-Purlins beams with a face-to-face configuration achieved better concrete confinement behavior than a separate configuration did; specifically, a higher bending capacity and ductility index by about +10.7% and +15.7%, respectively. Generally, the overall bending behavior of the tested specimens was not significantly affected when the infill concrete’s raw aggregates were replaced with 50% and 100% recycled aggregates; however, their bending capacities were reduced, at −8.0% and −11.6%, respectively, compared to the control specimen (0% recycled aggregates). Furthermore, a new theoretical model developed during this study to predict the nominal bending strength of the suggested CBPDS member showed acceptable mean value (0.970) and standard deviation (3.6%) compared with the corresponding test results.Keywords
Funding Information
- Investigation & Instrumentation Management Center (CRIM), Universiti Kebangsaan Malaysia (UKM) (GGPM-2020-001)
This publication has 44 references indexed in Scilit:
- Developments and advanced applications of concrete-filled steel tubular (CFST) structures: MembersJournal of Constructional Steel Research, 2014
- Behavior of concrete-filled steel tubular stub columns and beams using dune sand as part of fine aggregateConstruction and Building Materials, 2014
- Experimental behaviour of recycled aggregate concrete filled stainless steel tube stub columns and beamsThin-Walled Structures, 2013
- Behaviour of recycled aggregate concrete filled stainless steel stub columnsMaterials and Structures, 2013
- Behavior of CFST short column and beam with initial concrete imperfection: ExperimentsJournal of Constructional Steel Research, 2011
- Steel–concrete composite bridge deck slab with profiled sheetingJournal of Constructional Steel Research, 2009
- Finite element prediction on the structural performance of profiled steel sheet dry board structural composite system proposed as a disaster relief shelterConstruction and Building Materials, 2005
- Fire resistance performance of profiled steel sheet dry board (PSSDB) flooring panel systemBuilding and Environment, 2003
- New technologies of steel/concrete composite bridgesJournal of Constructional Steel Research, 2002
- Experimental and finite element study of profiled steel sheet dry board folded plate structuresThin-Walled Structures, 2000