Mechanical load distribution along the main cutting edges in drilling
Authors:
- Mihai-Bogdan LazarMLMihai-Bogdan Lazar
- Paul XirouchakisPXPaul Xirouchakis
- 1 February 2013
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 213 (2) , 245-260
Abstract
No abstract availableKeywords
This publication has 23 references indexed in Scilit:
- Experimental analysis of drilling fiber reinforced compositesInternational Journal of Machine Tools and Manufacture, 2011
- Specific machining forces and resultant force vectors for machining of reinforced plasticsCIRP Annals, 2011
- Cutting edge rounding: An innovative tool wear criterion in drilling CFRP composite laminatesInternational Journal of Machine Tools and Manufacture, 2009
- Drilling of carbon composites using a one shot drill bit. Part II: empirical modeling of maximum thrust forceInternational Journal of Machine Tools and Manufacture, 2006
- Drilling of carbon composites using a one shot drill bit. Part I: Five stage representation of drilling and factors affecting maximum force and torqueInternational Journal of Machine Tools and Manufacture, 2006
- Cutting Forces in Orthogonal Cutting of Unidirectional GFRP CompositesJournal of Engineering Materials and Technology, 1996
- The edge force components in oblique cuttingInternational Journal of Machine Tools and Manufacture, 1990
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. II — revised cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- An investigation of drill point sharpening by the straight lip conical grinding method—I. basic analysisInternational Journal of Machine Tool Design and Research, 1973