Methylene Blue and Reactive Blue 19 Dyes Removal Using Titania and Graphite Based Composite
- 10 November 2025
- journal article
- Published by Wiley in ChemistrySelect
- Vol. 10 (42)
Abstract
The rapid expansion of global industrialization has led to significant water pollution, primarily due to the discharge of wastewater containing organic contaminants like dyes, which are resistant to biodegradation and pose health risks. This study focuses on the removal of Methylene Blue (MB) and Reactive Blue 19 (RB 19) dyes using a cost‐effective titania–graphite oxide (GO‐TiO 2 ) composite synthesized via a modified sol–gel method. The composite was characterized using SEM, XRD, FT‐IR, and BET analysis, revealing its structural and textural properties. The study evaluated the sorption and photocatalytic efficiency of the composite in removing MB and RB 19 from water. Results showed that while the GO–TiO 2 composite had a larger surface area, pure GO exhibited higher sorption efficiency, likely due to the presence of surface functional groups. Photocatalytic activity under UV light was observed, with higher degradation rates for RB 19 compared to MB. The research highlights the potential of GO‐TiO 2 composites as an economical and environmentally friendly material for dye removal, though further optimization is needed to enhance its performance. The obtained composites show great photocatalytic efficiency up to 100% of photodegradation for low dye concentrations and high catalyst dose. Composites can be used up to three times without a significant decrease in activity.Keywords
This publication has 26 references indexed in Scilit:
- Mechanisms of dyes adsorption on titanium oxide– graphene oxide nanocompositesCeramics International, 2023
- TiO2/clay as a heterogeneous catalyst in photocatalytic/photochemical oxidation of anionic reactive blue 19Arabian Journal of Chemistry, 2019
- Synthesis of TiO2/Graphene oxide nanocomposites for their enhanced photocatalytic activity against methylene blue dye and ciprofloxacinComposites Part B: Engineering, 2019
- Synthesis, characterization, and dye sorption ability of carbon nanotube–biochar nanocompositesChemical Engineering Journal, 2014
- Nanocomposites of graphene oxide-hydrated zirconium oxide for simultaneous removal of As(III) and As(V) from waterChemical Engineering Journal, 2013
- Anionic dye removal from aqueous solutions using modified zeolite: Adsorption kinetics and isotherm studiesChemical Engineering Journal, 2012
- Enhanced chemical interaction between TiO2 and graphene oxide for photocatalytic decolorization of methylene blueChemical Engineering Journal, 2012
- Adsorption behavior of a textile dye of Reactive Blue 19 from aqueous solutions onto modified bentoniteApplied Surface Science, 2010
- Removal of cationic dyes from aqueous solutions by kaolin: Kinetic and equilibrium studiesApplied Clay Science, 2009
- Characteristics and microstructure of aqueous colloidal dispersions of graphite oxideCarbon, 2005