Effect of Cooling Rate on Material Properties in Homogenization Heat Treatment of 6060 Aluminum Alloy
Open Access
- 31 December 2024
- journal article
- Published by Sakarya University Journal of Science in Sakarya University Journal of Science
- Vol. 28 (6) , 1194-1201
Abstract
An important alloy family utilized in the extrusion sector is the 6xxx series of aluminum alloys, which can also be aged through heat treatment. Because of its excellent extrudability, it is easily formable. Before extrusion, formable aluminum alloys are typically heated through homogenization. With the homogenization process applied to the material, it is ensured that the product surface is clean and the microstructure that determines the extrusion speed is obtained with the controlled cooling applied after homogenization. In this study, homogenization heat treatment was carried out in continuous type homogenization furnaces of AA-6060 series Al billet produced with direct chill (DC) casting. In the cooling section, different cooling rates were obtained by changing the speeds of the fans and the effect of the cooling rate on the material properties were examined. According to X-ray diffraction (XRD) results, β-AlFeSi, α-AlFeSi and Mg2Si phases were observed in the alloys. The needle-shaped β-AlFeSi phase seen at the grain boundaries of the casting sample was observed by scanning electron microscope (SEM) and optic microscope (OM), where homogeneously heat-treated samples transformed into spherical form α-AlFeSi at the grain boundaries. Although the cooling rates did not have a significant and significant effect on the microstructure in homogenization, the saving obtained from the total electricity consumption of the turbo fans was 29.6%Keywords
Funding Information
- Bilecik Seyh Edebali University, Coordination of Scientific Research Project (2022-01.BŞEÜ.03-04)
This publication has 20 references indexed in Scilit:
- Influence of different homogenization heat treatments on the microstructure and hot flow stress of the aluminum alloy AA6082Materials Characterization, 2022
- Microstructure evolution during homogenization and hot workability of 7055 aluminum alloy produced by twin-roll castingJournal of Materials Research and Technology, 2021
- Production of aluminum AA7075/6060 compounds by die casting and hot extrusionJournal of Materials Processing Technology, 2020
- Effect of Homogenization Treatment and Microalloying with Mn on the Microstructure and Hot Workability of AA6060 Aluminum AlloysJournal of Materials Engineering and Performance, 2019
- In-situ study of phase transformations during homogenization of 6060 and 6063 Al alloysJournal of Physics and Chemistry of Solids, 2019
- Optimization of homogenization for a low alloyed AlMgSi alloyMaterials Characterization, 2013
- Influence of cooling rate after homogenization on microstructure and mechanical properties of aluminum alloy 7050Metals and Materials International, 2012
- Microstructures in the 6060 aluminium alloy after various severe plastic deformation treatmentsMaterials Characterization, 2011
- Hot profile extrusion of AA-6060 aluminum chipsJournal of Materials Processing Technology, 2009
- The effect of homogenization practice on the microstructure of AA6063 billetsJournal of Materials Processing Technology, 2004