Modelling and performance analysis of amorphous silicon solar cell using wide band gap nc‐Si:H window layer
Authors:
Open Access
- 1 November 2017
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 11 (6) , 666-675
Abstract
Poor charge transport mechanism and light‐induced degradation effects are among the key factors leading to the degraded performance of single‐junction amorphous silicon (a‐Si:H) solar cells. Existent photovoltaic configurations, based on amorphous silicon carbide (a‐SiC:H) window layer, have established efficiencies in the range of 7–10%. Limited performance of such devices has been addressed by replacing a‐SiC:H with a wide band gap (∼2 eV) hydrogenated nano‐crystalline silicon (nc‐Si:H) layer that reportedly exhibits crystalline properties at small scale. Here, the proposed solar cell based on p‐nc‐Si:H/i‐a‐Si:H (buffer)/i‐a‐Si:H/n‐a‐Si:H configuration has been simulated with SILVACO TCAD by analysing window and intrinsic absorber layers thickness, as well as doping concentrations. Along with the engineering of p/i interface, in‐depth evaluation of absorber defects parameters has also been undertaken in order to reduce the recombination rate. The simulated results of an optimised single‐junction device demonstrated an open‐circuit voltage (VOC) of 0.865 V, short‐circuit current density (JSC) of 21.7 mA/cm 2 , Fill factor (FF) of 0.69 and power conversion efficiency of 12.93%, which is promising when compared with the solar cell already reported. The proposed structure will provide the platform for further development of low cost and efficient multijunction thin‐film amorphous solar cell technology.Keywords
Funding Information
- Higher Education Commission, Pakistan (213‐63936‐2EG2‐123)
This publication has 37 references indexed in Scilit:
- Computer analysis of thin-film amorphous silicon heterojunction solar cellsJournal of Physics D: Applied Physics, 2011
- Wide-gap a-Si1−xCx:H solar cells with high light-induced stability for multijunction structure applicationsSolar Energy Materials and Solar Cells, 2011
- Enhanced power conversion efficiency of p-i-n type organic solar cells by employing a p-layer of palladium phthalocyanineApplied Physics Letters, 2010
- Comparison of a-SiC:H and a-SiN:H as candidate materials for a p-i interface layer in a-Si:H p-i-n solar cellsEnergy Procedia, 2010
- Electrical and optical properties of boron‐doped nanocrystalline silicon films deposited by PECVDPhysica Status Solidi (a), 2010
- Self-consistent optical parameters of intrinsic silicon at 300K including temperature coefficientsSolar Energy Materials and Solar Cells, 2008
- Performance analysis ofa‐Si:H p–i–n solar cells with and without a buffer layer at the p/i interfacephysica status solidi (c), 2004
- Thin‐film solar cells: an overviewProgress in Photovoltaics: Research and Applications, 2004
- Device simulations of nanocrystalline silicon thin-film transistorsSolid-State Electronics, 2003
- Development in Understanding and Controlling the Staebler-Wronski Effect in a-Si:HAnnual Review of Materials Research, 2001