Analytical Model for Temperature Prediction in Milling AISI D2 with Minimum Quantity Lubrication
Open Access
Abstract
Milling with minimum quantity lubrication (MQL) is now a commonly used machining technique in industry. The application of the MQL significantly reduces the temperature on the machined surface, while the cost of the lubricants is limited and the pollution caused by the lubricants is better controlled. However, the fast prediction of the milling temperature during the process has not been well developed. This paper proposes an analytical model for milling temperature prediction at the workpiece flank surface with MQL application. Based on the modified orthogonal cutting model and boundary layer lubrication effect, the proposed model takes in the process parameters and can generate the temperature profile at the workpiece surface within 1 min. The model is validated with experimental data in milling AISI D2 steel. With an average absolute error of 10.38%, the proposed model provides a reasonable temperature prediction compared to the experimental results. Based on the proposed model, this paper also investigates the effect of different cutting parameters on the cutting temperature. It is found that the application of the MQL decreases the temperature at the cutting zone, especially at the flank surface of the workpiece, which is due to the heat loss led by air-oil flow.Keywords
This publication has 37 references indexed in Scilit:
- Thermal analysis of minimum quantity lubrication-MQL grinding processInternational Journal of Machine Tools and Manufacture, 2012
- Measuring temperature of rotating cutting tools: Application to MQL drilling and dry milling of aerospace alloysApplied Thermal Engineering, 2012
- Temperatures in fine grinding with minimum quantity lubrication (MQL)The International Journal of Advanced Manufacturing Technology, 2011
- Chip formation in orthogonal cutting considering interface limiting shear stress and damage evolution based on fracture energy approachFinite Elements in Analysis and Design, 2011
- Machining of 6061 aluminium alloy with MQL, dry and flooded lubricant conditionsMaterials Letters, 2008
- Analysis of temperature during drilling of Ti6Al4V with minimal quantity of lubricantJournal of Materials Processing Technology, 2006
- The influence of minimum quantity of lubrication (MQL) on cutting temperature, chip and dimensional accuracy in turning AISI-1040 steelJournal of Materials Processing Technology, 2006
- Modeling of Cutting Temperature in Near Dry MachiningJournal of Manufacturing Science and Engineering, 2005
- A Slip-Line Field for Ploughing During Orthogonal CuttingJournal of Manufacturing Science and Engineering, 1998
- Mechanics of Machining: An Analytical Approach to Assessing MachinabilityJournal of Applied Mechanics, 1990